Accusplit Pedometer AX2710 User Manual

							DISPLAY MODE
•	 step:	STEP	mode	shows	your	step	count	since	last	reset,	up	to	100,000	steps.	
WEARING YOUR PEDOMETER
While gently holding the belt clip open, slide the pedometer 
onto your belt or the top edge of your pants or skirt. It should fit 
snugly and level, above one knee. 
Note: Your accelerometer pedometer no longer needs to be as 
vertical as possible.
The cover should be closed to minimize objects hitting your 
pedometer. To avoid losing or dropping your pedometer, use 
the included leash and clip to fasten the pedometer securely to 
your clothing. 
Attaching the Leash: Attach the pedometer to the leash by 
looping the leash through the pedometer clip. Next, loop the 
leash through the metal clip. Finally, clasp the waistband of 
your clothing with the metal clip. You can also use a safety pin to 
fasten the leash to your clothing, loop the leash through your belt 
or belt loop, or use a badge holder.  VIEWING YOUR RESULTS
Once you put on your pedometer with the cover closed, it will 
automatically begin to record your steps.
4-Second STEP DELAY FILTER
ACCUSPLIT has added a “4-second step delay filter” to reduce 
the counting of “false steps”. When beginning walking, the display 
will not show any “tallying of new steps,” until after 4 seconds of 
walking. Then, all the STEPS will be added to the display and 
new STEPS continue to be counted and displayed.
RESETTING YOUR PEDOMETER
Most people prefer to reset step counts daily. To reset: Press and 
hold the white RESET button for at least 2 seconds.
REPLACING THE BATTERY
When the display starts to dim or goes blank, it is time to replace 
the battery. Your pedometer uses one Type L1142 (LR43) 1.5 volt 
battery. To replace:
1. Insert a finger nail under the top right edge of the battery door 
to lift the door open and out of its slot.
2. Using a small “eye glasses” style screw driver, remove the  holding screw.
3. Remove the old battery and insert the new battery, + side up.
4. Replace the holding screw.
5. Carefully replace the battery door, first inserting the tab into its  slot, then carefully pushing the cover down until it snaps shut 
at the top edge.
ACCUSPLIT AX2710 Accelerometer Pedometer
INSTRUCTIONS
ACCUSPLIT, Inc.  •  7901 Stoneridge Drive, Suite 350  •  Pleasanton, CA 94588 USA
 800-935-1996  •  925-290-1900  •  FAX 925-290-1930  •  www.ACCUSPLIT.com  •  [email protected]
Eat Right! Walk More! Live Well !  The ACCUSPLIT Lifestyle
Congratulations on taking the first step to 
wellness with your purchase of an ACCUSPLIT  Accelerometer pedometer. Just put the pedometer on, and start walking!
179-1603
First, loop the
pedometer leash clip
Next, loop the metal 
clip, then clasp clothing
Or, loop a  
badge holder,   
then put into pocket
(Badge	holder	 	
not	included)Or, loop a belt or belt loop
9789
White: RESET
POWER UP and DISPLAY ON
Power UP the display, initially, from its battery saving, factory set, 
“hibernate mode”, by pressing a button for a second, until you see 
the display digits, then release the button.
Turn ON the display, from its battery saving “sleep mode” (which 
it enters after 5 minutes of no STEP counting) by moving your 
pedometer.