Addonics Technologies Internal DigiDrive Flash Reader AEIDDSAU User Manual

							 
ADDONICS TECHNOLOGIES 
Model: AEIDDSAU, AEIDDSAUWP (read only mode) 
 
The internal SATA / USB DigiDrive supports Type I, II 
CF Cards, CF Micro drive, SD, SDHC, miniSD (with 
adapter), Trans flash, SD HS (Secure Digital High 
Speed), MMC Cards (4-bit and 8-bit modes), RS-
MMC, MMC-Micro, MMC Plus, Smart Media, xD 
picture card- both H and M types, Memory stick, 
Memory stick PRO, MS Extreme III Type media, MS 
PRO, HS (4-bit mode). 
 
 
 
 
 
 
 
 
 
 
Mode Jumper (JP4): 
Note: Only applies on SATA connection 
 
 
I.  Setting up the device in SATA mode 
a.   Connect a 4-pin floppy power cable from PC to the 
internal SATA / USB DigiDrive. 
b.   Attach SATA cable from internal SATA / USB 
DigiDrive to the PC SATA port. 
 
The tables show drive icon and media detection 
behavior basing on the mode switch setting and the 
type of SATA port the internal SATA / USB DigiDrive is 
connected to. 
 
Open mode – force flash media to become Fixed disk 
type 
  Drive icon  Media Detection Hot Swap 
SATA port Icon appears only 
when flash media is 
inside Flash media is 
automatically 
refresh and 
detected when 
added or removed 
Non hot swap 
SATA port Icon appears only 
when flash media is 
inside Flash media 
detection requires 
manual refresh in 
Device Manager 
 
 Close mode – force flash media to become 
Removable disk type 
 
Drive icon Media Detection 
Hot Swap 
SATA port NOT RECOMMENDED 
Non hot swap 
SATA port Icon always there 
with or without flash 
media inside the 
DigiDrive Flash media 
automatically 
detected when 
added or remove  
 
 
 
II.  Setting up the device in USB Mode 
a.   Connect a 4-pin floppy power cable to the internal 
SATA / USB DigiDrive. 
b.   Attach USB 5-pin header from internal SATA / 
USB DigiDrive to USB header on PC. 
c.   The drive icon appears only when flash media is 
inside the internal SATA / USB
 DigiDrive.The drive 
icon will disappear and reappear during media 
change. 
 
Note for AEIDDSAUWP: If an unformatted flash media 
is use, no drive icon will show up in My Computer.
 
 
 
Media Priority 
 
When more than one media is inside the internal 
SATA / USB DigiDrive during bootup, the media that 
gets detected first is according to the priority shown 
below 
1. Compact Flash 
2. Smart Media / xD Picture card 
3. 
MMC / SD 
4. 
Memory Stick 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
TECHNICAL SUPPORT 
 
 
Email:   http://www.addonics.com/sales/query/ 
Internet:   http://www.addonics.com 
 
Technical Support (8:30 am to 6:00 pm PST) 
Phone:      408 453-6212 
Email: http://www.addonics.com/support/query/ 
USB 5-pin 
header Mode jumper JP4 
(close or open) 
SATA port 4-pin floppy 
power connector 
Pin 1