Home
>
Addonics Technologies
>
Flash / SSD Reader and adapter
>
Addonics Technologies Internal DigiDrive Flash Reader aeudmd4 User Manual
Addonics Technologies Internal DigiDrive Flash Reader aeudmd4 User Manual
Have a look at the manual Addonics Technologies Internal DigiDrive Flash Reader aeudmd4 User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 299 Addonics Technologies manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
ADDONICS TECHNOLOGIES
Model: AEUDMD4, AEUDMD4WP (read only mode)
Step 1 Mount the IDE DigiDrive PRO on a 3.5” drive bay.
Step 2 Connect a 4-pin floppy power cable from the PC power supply to the 4-pin
Molex power connector on the IDE DigiDrive PRO.
Step 3 By default, the IDE DigiDrive PRO is set as a master device. Set jumper on
IDE Master mode or Slave mode (JP2 ON = Master, JP2 OFF = Slave)
Step 4 Connect 40-pin IDE connector to IDE controller on motherboard using IDE
flat cable.
Note for AEUDMD4WP:
The IDE DigiDrive PRO supports hot swap.
If an unformatted flash media is use, no drive icon will show up in My Computer.
Media Priority
When more than one media is inside the internal IDE DigiDrive PRO during bootup,
the media that gets detected first is according to the priority shown below
1. Compact Flash
2. Smart Media / xD Picture card
3. MMC / SD
4. Memory Stick
TECHNICAL SUPPORT (8:30 am to 6:00 pm PST)
Phone: 408 453-6212
Email: http://www.addonics.com/support/query/
ADDONICS TECHNOLOGIES
Model: AEUDMD4, AEUDMD4WP (read only mode)
Step 1 Mount the IDE DigiDrive PRO on a 3.5” drive bay.
Step 2 Connect a 4-pin floppy power cable from the PC power supply to the 4-pin
Molex power connector on the IDE DigiDrive PRO.
Step 3 By default, the IDE DigiDrive PRO is set as a master device. Set jumper on
IDE Master mode or Slave mode (JP2 ON = Master, JP2 OFF = Slave)
Step 4 Connect 40-pin IDE connector to IDE controller on motherboard using IDE
flat cable.
Note for AEUDMD4WP:
The IDE DigiDrive PRO supports hot swap.
If an unformatted flash media is use, no drive icon will show up in My Computer.
Media Priority
When more than one media is inside the internal IDE DigiDrive PRO during bootup,
the media that gets detected first is according to the priority shown below
5. Compact Flash
6. Smart Media / xD Picture card
7. MMC / SD
8. Memory Stick
TECHNICAL SUPPORT (8:30 am to 6:00 pm PST)
Phone: 408 453-6212
Email: http://www.addonics.com/support/query/
Mode jumper JP2 (close or open)
40-pin IDE connector
4-pin floppy power connector Mode jumper JP2 (close or open)
40-pin IDE connector
4-pin floppy power connector