Addonics Technologies Universal Flash Media Duplicator UFMDU User Manual

							 
ADDONICS TECHNOLOGIES 
Model: UFMDU 
 
Note:  Make sure that the capacity of the target card is equal or 
larger than the source card.  
 
For example, on the label of the card, it might identify both cards 
as 8GB but the actual size differs. When these type of cards are 
used on the Universal Flash Media duplicator, when you start 
duplicating, you will receive a “Target Not Ready” error.  To 
resolve this issue, you need to decrease the card size of the 
source card. To do this, navigate to: 6.Setup > 6.2Copy Size and 
use the button arrows to decrease the card size of the source 
card by increments of 1%. 
 
I. Installing card into the Universal Flash Media Duplicator 
 
            
 
 
 
Step 1 
Insert the Source card into the source bay.  
 
Note:  Only one type of source card can inserted on the 
source bay at a time. 
 
Step 2 
Insert the Target card into the target bay.  
 
Note:  Only one type of target card can inserted on the 
source bay at a time. 
 
 
II. Connecting the power cable and powering on 
 
a. Connect the power cord provided from the wall outlet to the 
back of the tower. 
b. Push the power switch button to turn on the HDD duplicator. 
 
 
 
III. The Duplicator Panel 
 
There are four buttons and an LCD on the panel of HDD 
Duplicator. 
1 – LCD shows a function or a message. 
2 – it is used to scroll up function menus. 
3 – it is used to scroll down function menus. 
4 – it is used to execute a function. 
5 – it is used to cancel a function.
  
IV. Duplicating a card 
When the duplicator powers on, it initializes and goes through the 
steps below 
 
 
Copy HDD copies data directly from the source card to the target 
card.  
 
Verify that the power LEDs of the flash reader light up. 
 
Press ENT button to begin copy. The system will auto-detect the 
card and show the following info on the LCD. 
  
Verify that the power LEDs of the flash reader are blinking 
indicating drive activity. 
 
The LCD will show the following info during the copying process: 
remaining time, completed percentage. The copy speed, capacity 
and time will vary depending on the source hard disk. Once the 
copying process is complete the LCD will display the following 
results. 
  
 
 
The complete user manual of the HDD Duplicator Panel can 
found in the Driver Disk under User Guides or can be 
downloaded from 
http://www.addonics.com/support/user_guides/ 
 
 
Technical Support 
 
Contact Information 
Phone:  408-573-8580    
Fax:  408-573-8588 
Email:  http://www.addonics.com/sales/query/ 
Internet:  http://www.addonics.com 
 
TECHNICAL SUPPORT 
Phone:  408-453-6212 
Hours:  8:30 am - 6:00 pm PST 
Email:            http://www.addonics.com/support/query/ 
Duplicator Panel 
Source Bay  
Target Bay 
Source and target flash reader LED 
Power Switch 
Duplicator  Power LED