Agio International Boatshaped Inlaid Glass Table User Manual

							PARTS LIST DESCRIPTION PVC NUT COVERPVC BOLT COVERHEX BOLT DRIVERHEX WRENCHWASHERNUT1/4 X 25MM BOLT1/4 X 20MM BOLTTOPSIDE SUPPORTTABLE LEGLEG CONNECTOR 
BRACKETTABLE RIMGLASS TOPQTY./PCS88111682624111MODEL # 55-40685-22-702
Page 2A
BCDEFGHIJKLMIMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!GLIIHMFFLLIIStep3:Attach a leg to the leg connector bracket by carefully 
           guiding the bolts already in place on the table legs (each leg           has two bolts) through the holes in the leg connector bracket.           Add a washer and a nut to the end of each bolt. Hand tighten 
           3-4 revolutions only. Do not tighten completely.  Repeat on 
           other three legs
Step4:Attach topside support to leg connector bracket using a 
           1/4” x 25mm bolt and a washer as shown in diagram.  Guide           bolt with washer through hole in leg connector bracket, into            the pre-drilled hole in the topside support.  Hand tighten 3-4
           revolutions only. Do not tighten completely.  Repeat for 
           opposite topside support.Step5:After making any necessary adjustments to the alignment of
           the table legs and the leg connector bracket, use the hex bolt           driver and hex wrench to tighten all nuts and bolts.  Note:
           each bolt must be tightened a few revolutions at a time.  In           order to apply equal pressure to all bolt joints, we recommend           working in a cross corner (”X” fashion).  Repeat until all            bolts are tight.  Do not over tighten.  Over tightening may           strip bolts.  Cover all nuts and bolts with PVC covers.
Step6:With the help of another person, turn the table in the upright
           position.  Note the clear bumpers spaced evenly throughout           the inside of the rim. Carefully place glass inside the rim,            resting on the clear bumpers.  Your table is now ready for 
           use.  If you have any questions, please call our Customer           Service Center at 1-800-416-3511Step1:Carefully remove glass and set aside until Step 6 .  Lay 
            glass flat--do not stand glass on edge.  Remove all             protective materials and set parts on a flat, non-abrasive             surface.  Identify parts packed in carton against the parts             list.  If you are missing an parts or are unsure how to             proceed with assembly, call our Customer Service Center             at 1-800-416-3511.  Do not attempt assembly if any 
            parts are missing or damaged.
Step2:Place the table rim (without glass) upside down on a flat, 
            non-abrasive surface.  Attach table leg to rim using a             1/4” x 20mm  bolt and washer as shown in diagram.              Guide bolt through hole in table leg, into pre-drilled hole            in the table rim.  Hand tighten 3-4 revolutions only.  Do             not tighten completely.  Some adjustments may be             necessary to ensure proper alignment of the table legs.              Repeat for other three legs.  Attach topside supports with            1/4” x 20mm bolts and washers using same procedure.