Agio International Round Captured Glass Table User Manual

							IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!Page 2MODEL # 50-48-09PARTS LIST DESCRIPTION PVC BOLT COVERHEX BOLT DRIVERTABLE LEGLEG
CONNECTOR RINGTABLE  RIM
WITH  GLASSQTY./PCS1411BOLTMETAL PLATE488PLASTIC FITTINGStep 1:Identify all parts packed in the carton against the
            parts list. Remove all protective materials.  If you             are missing any parts or are unsure as how to proceed             with the assembly, please call our Customer Service             Center immediately  (800) 416-3511.  Do not attempt
            to assemble table if any parts are missing or damaged.Step 2: With the help of another person, place tabletop upside
            down on a flat, non-abrasive surface to avoid scratching            the glass or rim.  Note the plastic fittings on the inside of            the table rim.  These fittings slide.  Adjust, if necessary, 
            by sliding the fittings into proper position as shown in            diagram below.  If applicable, adjust flat  plastic             supports so they are spaced evenly throughout            the inside of the rim.  This will ensure best possible            support of the glass in the table.  Make sure clear             bumpers are in place in the small holes on the table legs.              Guide each of the table legs into the plastic fittings in the            table rim.          Step 3:Attach one leg to the leg connector bracket using two 
            bolts. Add a metal plate to the bolts and guide through            the inside of the connector bracket into the fixed nuts            inside of the table leg.  Hand tighten three or four            revolutions only.  Important note:  Hand tighten 
            only as some adjustments may be necessary to 
            ensure legs  are properly aligned.  Repeat procedure  
            on other three legs, adjusting  as necessary to ensure             the legs are properly aligned.Step 4:At this time tighten all bolts using the Hex Bolt 
            Driver provided.  Important note: each bolt should             be tightened a few revolutions at a time.  We
            recommend working in a cross corner “X” fashion,             alternating between bolts. This will tighten the             frame evenly by placing equal pressure on all bolt             joints.  Do not over tighten.  Cover  all bolts with 
            PVC bolt covers provided.Step 5:With the help of another person, carefully turn the 
            table in the upright position. Your table is now ready
            for use.  If you have any questions, please call our            Customer Service Center at  (800) 416-3511.