Acer Aspire 4930 4930G Series User Manual

							Chapter 381
6.Place the antenna cable as shown to avoid damaging them. 
						

							82Chapter 3
Removing the LCD Module
1.See “Removing the Battery Pack” on page 60.
2.See “Removing the Lower Covers” on page 63.
3.See “Removing the WLAN Board Module” on page 66.
4.See “Removing the Keyboard” on page 76.
5.See “Removing the Antenna” on page 78.
6.Remove the two securing screws from the bottom of the chassis.
7.Turn the computer over. Disconnect the three LCD interface cables from the chassis.
StepSize (Quantity)ColorTo r q u e
6 M2.5*5 NL (2) Black 
						

							Chapter 383
8.Remove the six securing screws from the LCD module.
9.Carefully remove the LCD module from the chassis. 
StepSize (Quantity)ColorTo r q u e
8 M2.5*8 NL (4) Black
8 M2.5*5 NL (2) Black 
						

							84Chapter 3
Removing the Upper Cover
1.See “Removing the Battery Pack” on page 60.
2.See “Removing the SD dummy card” on page 61.
3.See “Removing the ExpressCard dummy card” on page 62.
4.See “Removing the Lower Covers” on page 63.
5.See “Removing the DIMM Module” on page 65.
6.See “Removing the WLAN Board Module” on page 66.
7.See “Removing the Hard Disk Drive Module” on page 68.
8.See “Removing the Optical Drive Module” on page 70.
9.See “Removing the Switch Cover” on page 74.
10.See “Removing the Keyboard” on page 76.
11 .See “Removing the LCD Module” on page 82.
12.Turn the computer over. Remove the eight screws on the bottom panel. 
StepSize (Quantity)ColorTo r q u e
12 M2.5*8 NL (8) Black 
						

							Chapter 385
13.Turn the computer over. Remove the seven screws on the top panel. 
14.Disconnect the five cables from the mainboard as shown.
StepSize (Quantity)ColorTo r q u e
13 M2.5*5 NL (7) Black
AB
C
D E 
						

							86Chapter 3
Disconnect A as shown. Release the securing latches and disconnect B as 
shown.
Release the securing latches and disconnect C as 
shown.Release the securing latches and disconnect D as 
shown.
Release the securing latches and disconnect E as shown. 
						

							Chapter 387
15.Remove the upper cover by lifting upward from the chassis, rear edge first.
16.Turn the upper cover over. The upper cover appears as follows. 
						

							88Chapter 3
Removing the Touch Pad Bracket
1.See “Removing the Battery Pack” on page 60.
2.See “Removing the SD dummy card” on page 61.
3.See “Removing the ExpressCard dummy card” on page 62.
4.See “Removing the Lower Covers” on page 63.
5.See “Removing the DIMM Module” on page 65.
6.See “Removing the WLAN Board Module” on page 66.
7.See “Removing the Hard Disk Drive Module” on page 68.
8.See “Removing the Optical Drive Module” on page 70.
9.See “Removing the Keyboard” on page 76.
10.See “Removing the LCD Module” on page 82.
11 .See “Removing the Upper Cover” on page 84.
12.Disconnect the Touch Pad cable from the Touch Pad board.  
						

							Chapter 389
13.Move the Finger Print Reader FFC cable out of the way to prevent damage. 
14.Remove the two securing screws from the Touch Pad bracket.
StepSize (Quantity)ColorTo r q u e
14 M2*3 NL (2) Black 
						

							90Chapter 3
15.Remove the Touch Pad bracket.
IMPORTANT:The Touch Pad cannot be removed individually. To replace the Touch Pad, replace the entire 
Upper Cover.