Acer Aspire 5534 Service Guide

							Chapter 3121
Replacing the I/O Board
1.Connect the I/O Board Cable to the I/O Board.
2.Apply the adhesive to secure the I/O Board cable to the Lower Cover.
3.Insert the board into the lower cover so the white tab is under the securing clip in the lower cover, taking 
care to align the screw holes. 
						

							122Chapter 3
4.Insert the single screw to secure the I/O Board to the Lower Cover.
5.Connect the cable to the Mainboard.
StepSizeQuantityScrew Type
I/O Board M2.5*6 1 
						

							Chapter 3123
6.Connect the FFC to the Mainboard and close the locking latch.
Replacing the Bluetooth Module
1.Insert the Bluetooth Module right side first and press down on the top to attach it to the Lower Cover.
2.Connect the cable to the Bluetooth Module. 
						

							124Chapter 3
3.Connect the Bluetooth cable to the Mainboard.
Replacing the Media Board
1.Insert the Media Board FFC through the cover as shown.
2.Holding the mylar back, insert the Media Board under the securing clips in the upper cover and place on 
the upper cover so the aligning pins are in the holes. 
						

							Chapter 3125
3.Adhere the mylar to the Media Board and insert the single screw to secure the Media Board to the Lower 
Cover.
Replacing the Speaker Modules
1.Place the right side speaker onto the Lower Cover as shown.
StepSizeQuantityScrew Type
Media Board M2.5*3 1 
						

							126Chapter 3
2.Place the right side speaker into the Lower Cover and peel back the mylar to expose the wire guides as 
shown.
3.Peel back the mylar and insert the Speaker Cable into the cable channel. Ensure that the cable passes 
under all cable clips. 
						

							Chapter 3127
4.Insert the four screws to secure the Speakers to the Upper Cover.
Replacing the Power Board
1.Insert the Power Board into the Lower Cover so the slot on the Power Board hooks onto the securing tab 
in the upper cover.
IMPORTANT:The FFC is soldered to the power board. Take care when lifting to minimize bending of the 
connection, lest breakage occur.
2.Adhere the FFC to the Speaker Module.
StepSizeQuantityScrew Type
Speaker Module M2.5*3 4 
						

							128Chapter 3
3.Insert the single screw to secure the Power Board to the Lower Cover.
Replacing the Touchpad Bracket
1.Slide the Touchpad Bracket into the slots in the upper cover.
StepSizeQuantityScrew Type
Power Board M2.5*3 1 
						

							Chapter 3129
2.Push the bracket down until it is secured under the tabs along the top edge.
3.Insert the single screw to secure the Touchpad Bracket to the Upper Cover.
StepSizeQuantityScrew Type
TouchPad Bracket M2*3 1 
						

							130Chapter 3
Replacing the Button Board
1.Insert the Mainboard FFC through the cover as shown.
2.Replace the three screws to secure the button board to the Upper Cover.
3.Slide the aminboard FFC through the cutout in the upper cover and adhere the FFCs to the upper cover.
StepSizeQuantityScrew Type
Button Board M2*3 4