Home > Addonics Technologies > Encryption > Addonics Technologies Ruby Cipher for 25 HDDSSD rcdcs256 User Manual

Addonics Technologies Ruby Cipher for 25 HDDSSD rcdcs256 User Manual

Add to Favourites
    Download as PDF

    View the Addonics Technologies Ruby Cipher for 25 HDDSSD rcdcs256 User Manual for free. All the Addonics Technologies manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview Comments
    Page 1 Addonics T E C H N O L O G I E S Ruby Cipher AES 256-bit Drive Cartridge System RCDCS256S & RCDCS256U User’s Guide FCC Warning Statement This equipment has been tested and found to comply with the limits for a class B digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency...
    Page 2 IMPORTANT There is no back door for the Ruby Cipher encrypted hard drive if the key is lost or stolen. To ensure there is a spare key, your Ruby Cipher bundled kit comes with one pair of Ruby Cipher keys. These 2 keys have identical encryption code. One of these keys should be kept in a safe and secure location and can be sent back to Addonics for duplicating additional keys. If you are down to the last key, be sure to make a back up of all the data stored inside your encrypted hard drive...
    Page 3 Step 6 Put the top cover on by holding it in near vertical position and sliding the two metal clips inside the two small slots on the rear of the bottom cover. Step 7 Lower the front of the top cover and making sure the two covers lined up properly. Tighten the small retaining screw on the front of the bottom cover to close the enclosure. Ruby Enclosure Switch: INT: This mode is used when the enclosure is placed inside a drive cradle. For drive cartridge...
    Page 4 Model: RCDCS256U This Ruby model will hot-swap. Step 1: Connect the SATA to USB2.0 converter to the SATA interface of the cradle. Step 2: Connect the Y-cable that came with converter to the 4-pin floppy connector on the converter. The other end would connect to your system’s power supply. This power connection provides power to both converter and the ruby drive cartridge system. Step 3: For data connection, you can either use...
    Start reading Addonics Technologies Ruby Cipher for 25 HDDSSD rcdcs256 User Manual

    Related Manuals for Addonics Technologies Ruby Cipher for 25 HDDSSD rcdcs256 User Manual

    All Addonics Technologies manuals