Static Roof Vents
1.) POSITIONING THE VENTS ON THE ROOF 
Position the vents evenly spaced across the roof, below the ridgeline so that the vents can 
only be seen from one side of the house, yet no greater than 2 feet below the ridgeline.  
2.)  DRILL THE GUIDE HOLE 
Adjust placement of the vents to avoid drilling through any rafters.  Drill a guide hole near the 
center position of each vent.  
3.)  OUTLINING THE HOLE 
Mark correct diameter for the vent you have selected using the chart below. 
4.)...
                                            

                                                    WARNING: Read all warning messages and instructions 
before starting installation of this fan. Failure to follow these 
safety instructions can result in injury or even death. If you 
need assistance in understanding these instructions or have 
questions or comments, please call 1 (309) 692-6969.
ELECTRICAL HAZARDS
DANGER:  The electrical installation and wiring of this fan 
must be done by a qualified electrician in accordance with 
all local codes and standards, including fire-rated construc-
tion....
                                            

                                                    
Part No. 18365
Installation Instructions
Use this unit only in the manner intended by the manufacturer. 
If you have any questions, contact the manufacturer. 
Utilice esta unidad solamente de la manera indicada por el 
fabricante.  Si tiene alguna duda, contacte al fabricante.
Roof-Mounted Solar Attic Ventilator Ventilador de ático a energía solar, de montaje en techoModel NPSP8WW Modelo NPSP8WWImportant Safety Information Información importante de seguridad
IMPORTANT:    Read  all  warning  messages...
                                            

                                                    
Part No. 18365
Installation Instructions
Use this unit only in the manner intended by the manufacturer. 
If you have any questions, contact the manufacturer. 
Utilice esta unidad solamente de la manera indicada por el 
fabricante.  Si tiene alguna duda, contacte al fabricante.
Roof-Mounted Solar Attic Ventilator Ventilador de ático a energía solar, de montaje en techoModel NPSP8WW Modelo NPSP8WWImportant Safety Information Información importante de seguridad
IMPORTANT:    Read  all  warning  messages...
                                            

                                                    WA R NING:Read all warning messages and instructions
before starting installation of this fan. Failure to follow these
safety instructions can result in injury or even death. If you
need assistance in understanding these instructions or have
questions or comments, please call 1 (309) 693-6969.
ELECTRICAL HAZARDS
DANGER:The electrical installation and wiring of this fan
must be done by a qualified electrician in accordance with all
local codes and standards, including fire-rated construction.
Failure to...
                                            

                                                    SHINGLEOVERFILTEREDRIDGEVENT
Installation Instructions
Fits roofs with 3/12 to 16/12 pitches.
1.On existing roofs, remove cap shingles. Mark
slot width at both ends of ridge. Use slot guides
imprinted on vent and refer to drawings below.
Snap chalk line on both sides of ridge.
4.Prefasten first section using roofing nails
through predrilled nail bosses. Continue to 
prefasten remaining sections, making sure 
support ribs are flat on the roof and filter is
secure between shingles and vent.5.Use utility...
                                            

                                                    SHINGLEVENT®II - 7A & II - 9A
Installation Instructions
ROOF PITCH:
PRODUCT FEATURES:CUSTOMER SERVICE:
BEFORE YOU INSTALL - Install only one type of exhaust vent, remove or plug any existing vents\
 (gable vents, roof louvers, wind turbines and power fans). Install adequate Intake Ventilation for a Balanced System (50% Exhaust & 50% Intake) in accorda\
nce with state and local code requirements. Intake vents must be installed low at the roof’s edge or in the soffit/undereave. Products such as Air Vent’s...
                                            

                                                    SHINGLEVENT®II
Installation Instructions
ROOF PITCH:
PRODUCT FEATURES:CUSTOMER SERVICE:
BEFORE YOU INSTALL - Install only one type of exhaust vent, remove or plug any existing vents (gable vents, roof louvers, wind turbines and power fans). Install adequate Intake Ventilation for a Balanced System (50% Exhaust & 50% Intake) in accordance with state and local code requirements. Intake vents must be installed low at the roof’s edge or in the soffit/undereave. Products such as Air Vent’s Continuous Soffit...
                                            

                                                      Part No. 18381 
Installation Instructions
 
Use this unit only in the manner intended by the manufacturer. 
If you have any questions, contact the manufacturer. 
Utilice esta unidad solamente de la manera indicada por el 
fabricante.  Si tiene alguna duda, contacte al fabricante.
 
Gable-Mounted Solar Attic Ventilator 
Ventilador de ático a energía solar, de montaje en el alero Model NPSG8 
Modelo NPSG8 Important Safety Information 
Información importante de seguridad 
 
IMPORTANT:  Read all warning...
                                            

                                                    Part N o.  1838 2
Installation  Instructions
Use this  u n it on ly  in  the  m ann er inten de d b y the  manufact ure r. 
If  yo u ha ve  a n y  que stions,  conta ct  the  manu factu rer. 
U tili ce  e sta  un idad  s o la m ente  de  la  ma nera  indi cada  por  el  
fabrica nte.   Si tien e alg un a du da,  contacte  al  fabrica nte.
Ro of- M oun ted  S olar  A ttic V entilator 
Ventila dor de ático a en ergía solar, de m on taje  en tec ho
Model SC 8BL 
Model o SC8B L 
Im por tant Sa fety  I n form...