Home > Antennacraft

Antennacraft User Manuals

The manuals from this brand are divided to the category below. You can easily find what you need in a few seconds.
Antennacraft User Manuals
                                                    10G200 Series                   TV • FM  High-Gain UHF/VHF/FM 
Mast Mount UHF/VHF/FM Amplifier 
with Switchable FM Trap
Models 10G201 & 10G221  provide up 
to 16dB VHF gain and 22dB UHF gain. 
Intended for mixed signal areas where 
both  strong  and  weak  transmissions 
are present.
Models 10G202  & 10G222 provide up 
to 29dB VHF gain and 29dB UHF gain. 
These models are not intended for use 
in metro areas, as it could cause signal 
overload. Intended for deep fringe areas 
where all transmissions are...
                                            
                                                     
Thank you for purchasing your heavy-
duty 3-foot antenna mast tripod from 
Antennacraft. Your tripod makes it easy 
to install an outdoor antenna on your 
roof.
 
What’s Included
Tripod
5/16 Inch Bolts (6)
L-Bracket
Pitch Pads (3)
Foot Brackets (3, two are attached)
¼ Inch Bolt 
Lockwasher 
Lag Bolts (6)
Square Nuts (6)
Hex Nuts (7)
User’s Guide
 
Limited Warranty
This product is warranted by 
Antennacraft against manufacturing 
defects in material and workmanship 
under normal use for ninety (90)...
                                            
                                                    1/1Patent Pending
Please read this u\yser’s guide before usi\yng your ne\f antenna\y.
1500080	User’s	Guide
H D T V	I N D O O R	
A N T E N N A
AMPLIFIED    OMNIDIRECTIONAL
2 34567
8
Printed in 
China05B11
1500080
© 2011. Ignition L.P\y.  
All rights reserve\yd.  
Antennacraft is a \yregistered 
trademark used by I\ygnition L.P.
On a Wa\f\f:
1.
 Drill t\fo holes int\yo the \fall at the d\yistance that fits 
the antenna mounti\yng holes, about \b¾ \yinches (120 
mm) apart.
2.
 Thread scre\fs (not...
                                            
                                                    BEFORE YOU BEGIN
Read this manual and Consumer Product Safety Commission
information. For your safety and convenience, plan each step of
the installation and purchase the necessary hardware in advance.
The order in which you perform the steps and the hardware re-
quired depends on the mounting and connection methods you
choose.
We recommend two people assemble the entire antenna on the
ground, then mount the assembled antenna on the mast. The
following steps are required to assemble your antenna depend-...
                                            
                                                    Model Number:5884
General:
Channels2 - 69Electronic Elements25Output Impedance 300 ohms
Physical:
Boom Length 58Maximum Width 102Vertical Height 25Turning Radius 58Element Diameter .375Shipping Weight 5.1 lbs.Carton Dimensions 6.375 x 5.875 x 58.5
Performance:
1Gain (dB)    VHF Low Band2.5VHF High Band6.5UHF Band6.0
2Half-Power Beamwidth (deg.)    VHF Low Band70.0VHF High Band39.8UHF Band45.4
3Front-To-Back Ratio (dB)    VHF Low Band7.3VHF High Band9.0UHF Band9.9
1:  Over Half-Wave Tuned Dipole (Ch. 2 -...
                                            
                                                    5MS921_English060811_pg1.pdf 
                                            
                                                    Antennacraft Specification Sheet
Model Number:5MS921
General
Channels/Frequency:2 - 69
75
pHYPhysical
Maximum Width (in):20.6
V2.00 (6.0 w/ mast bracket)
Turning Radius (in):10.5
6.0
22 x 21 x 3
Antenna Performance
Average Gain Over Reference Dipole (dB):    
Low Band:-25.4
-10.8
-5.9
Half-Power Beamwidth (deg.):    
Low Band:NA
High Band:NA
UHF Band:NA
Front-To-Back Ratio (dB):    
Low Band:NA
High Band:NA
UHF Band:NA
Amplifier Performance
VHF Band:15
20
VHF Band:< 3.9
< 2.3
5MS921 spec...
                                            
                                                    BEFORE YOU BEGIN
Read this manual and Consumer Product Safety Commission
information. For your safety and convenience, plan each step of
the installation and purchase the necessary hardware in advance.
The order in which you perform the steps and the hardware re-
quired depends on the mounting and connection methods you
choose.
We recommend two people assemble the entire antenna on the
ground, then mount the assembled antenna on the mast. The
following steps are required to assemble your antenna depend-...
                                            
                                                    Model Number:AC-9
General:
Channels2 - 69Electronic Elements12Output Impedance 300 ohms
Physical:
Boom Length 30Maximum Width 98Vertical Height 4Turning Radius 50.5Element Diameter .375Shipping Weight 2.8 lbs.Carton Dimensions 5.75 x 4.75 x 51
Performance:
1Gain (dB)    VHF Low Band0.4VHF High Band3.7UHF Band3.0
2Half-Power Beamwidth (deg.)    VHF Low Band75.7VHF High Band54.8UHF Band52.1
3Front-To-Back Ratio (dB)    VHF Low Band1.0VHF High Band7.5UHF Band6.9
1:  Over Half-Wave Tuned Dipole (Ch. 2 -...
                                            
                                                    
092C:rebmuN ledoM
General:
Channels2 - 69Electronic Elements29Output Impedance 300 ohms
Physical:
Boom Length 78Maximum Width 108.5Vertical Height 25Turning Radius 63.5Element Diameter .375Shipping Weight 6.3 lbs.Carton Dimensions 6.0 x 6.25 x 59.75
Performance:
1Gain (dB)VHF Low Band2.8VHF High Band6.0UHF Band7.9
2Half-Power Beamwidth (deg.)VHF Low Band74.0VHF High Band48.5UHF Band55.2
3Front-To-Back Ratio (dB)VHF Low Band10.6VHF High Band13.7UHF Band11.6
CEA Color Code: VHF Low BandYellow/GreenVHF...
                                            
                                                    
Step 2       Unfolding the Elements
1.  Hold the main boom’s elements near the pivot points and pull 
them away from the boom until they snap into the support insu-
lators.
Caution: To avoid damage to the elements, do not pull them near 
their outer ends. Once the elements are locked into position, do not 
attempt to unlock them. Doing so might break the elements.
2.  Hold  each  wing  boom  and  turn  its  elements  until  they  snap 
squarely into place (perpendicular to the wing boom). 3.  
Set up...
                                            
                                                    
094C:rebmuN ledoM
General:
Channels2 - 69Electronic Elements50Output Impedance 300 ohms
Physical:
Boom Length 150Maximum Width 108.5Vertical Height 38.5Turning Radius 89.25Element Diameter .375Shipping Weight 10.6 lbs.Carton Dimensions 8.0 x 6.5 x 72
Performance:
1Gain (dB)VHF Low Band5.0VHF High Band8.8UHF Band9.3
2Half-Power Beamwidth (deg.)VHF Low Band70.3VHF High Band39.0UHF Band58.0
3Front-To-Back Ratio (dB)VHF Low Band15.5VHF High Band16.9UHF Band14.3
deR/neerG .tL/neerG/wolleY :edoC roloC AEC
1:...
                                            
                                                    
BEFORE YOU BEGIN
Read this manual and Consumer Product Safety Commission information. 
For  your  safety  and  convenience,  plan  each  step  of  the  installation  and 
purchase  the  necessary  hardware  in  advance.  The  order  in  which  you 
perform the steps and the hardware required depends on the mounting and 
connection methods you choose.
We recommend two people assemble the entire antenna on the ground, then 
mount the assembled antenna on the mast. The following steps are required 
to...
                                            
                                                    Model Number:CCS-1843
General:
Channels2 - 69Electronic Elements54Output Impedance 300 ohms
Physical:
Boom Length 180Maximum Width 110Vertical Height 38Turning Radius 105Element Diameter .375Shipping Weight 11.8 lbs.Carton Dimensions 6.5 x 6.5 x 101
Performance:
1Gain (dB)    VHF Low Band6.0VHF High Band9.1UHF Band9.3
2Half-Power Beamwidth (deg.)    VHF Low Band66.7VHF High Band41.8UHF Band36.4
3Front-To-Back Ratio (dB)    VHF Low Band19.6VHF High Band17.2UHF Band16.1
1:  Over Half-Wave Tuned Dipole (Ch....