Land Rover 300tdi Diesel Engine Overhaul 1997 Bookmarks Rover Manual

ENGINE
DESCRIPTION AND OPERATION7
ROCKER SHAFT AND COVER
1.Rocker cover flange nuts
2.Sealing washer
3.Oil filler cap
4.Rocker cover
5.Rocker cover gasket
6.Rocker shaft
7.Rocker shaft pedestal
8.Flange bolt
9.Washer10.Rocker arm bush
11.Adjusting screw
12.Locknut
13.Rocker arm
14.Spacer
15.Pedestal stud
16.Nut
17.Crankcase breather cyclone unit
18.O ring 

ENGINE
8
DESCRIPTION AND OPERATION 

ENGINE
DESCRIPTION AND OPERATION9
CYLINDER HEAD
1.Valve cap
2.Collets
3.Valve spring cup
4.Valve spring
5.Valve spring seat
6.Valve stem seal
7.Valve guide
8.Exhaust valve seat
9.Exhaust valve
10.Inlet valve seat
11.Inlet valve
12.Cylinder head bolt - M12 - long
13.Cylinder head bolt - M12 - short
14.Cylinder head bolt - M1015.Heater hose adaptor
16.Engine lifting brackets
17.Core plugs
18.Cylinder head gasket
19.Thermostat housing gasket
20.Coolant filler plug
21.Thermostat housing
22.Thermostat...

ENGINE
10
DESCRIPTION AND OPERATION 

ENGINE
DESCRIPTION AND OPERATION11
TIMING BELT REAR COVER AND GEARS
1.Camshaft oil seal
2.Gasket
3.Crankshaft front oil seal
4.Timing belt rear cover
5.Injection pump drive gear
6.Hub plate
7.Nut - injection pump hub
8.Bolt - injection pump hub plate
9.Camshaft drive gear
10.Washer - camshaft drive gear11.Bolt - camshaft drive gear
12.Idler pulley
13.Retaining nut
14.Crankshaft gear
15.Bolt - timing belt tensioner pulley
16.Spacer - timing belt tensioner pulley bolt
17.Timing belt tensioner pulley and...

ENGINE
12
DESCRIPTION AND OPERATION 

ENGINE
DESCRIPTION AND OPERATION13
TIMING BELT AND FRONT COVER
1.Timing belt
2.Gasket
3.Access plate
4.Bolt - access plate
5.Timing belt front cover6.Bolts - timing belt front cover
7.Wading plug
8.Oil seal
9.Crankshaft pulley
10.Pulley bolt 

ENGINE
14
DESCRIPTION AND OPERATION 

ENGINE
DESCRIPTION AND OPERATION15
OPERATION
The 300 TDi is a 4 cylinder, water cooled,
turbocharged diesel engine with a capacity of 2.5
litres.
The cast iron cylinder block is integral with the
crankcase and incorporates direct bored cylinders.
The crankshaft is carried in 5 main bearings,
end-float being controlled by thrust washers which
are positioned on both sides of the centre main
bearing.
The flywheel/drive plate housing is an aluminium
alloy casting secured to the rear of the cylinder
block, it...

ENGINE
16
DESCRIPTION AND OPERATION