Aaxa Projector Oem 250 User Manual

OEM-250 Micro Projector
User Manual  

Table of Contents       1
Warnings        2
Package Contents       3
Product Overview       4
Keypad & Remote Control Functions       5
General Operation       6
External Inputs       8
PMP Menu System                     10
 Videos       12
 Pictures       14
 Music        16
 eBooks       19
 Games       21
 Settings       25
Troubleshooting       27
Specifications	 	 	 	 	 	 	 28
Table of Contents
1  

Warnings
*Do not operate the Projector in direct sun-
light or near heat sources such as heaters, 
fires,	and	stoves	 as	this	 may	 cause	 a	fire	
hazard.
*Do not operate the projector close to 
sources of steam or oil such as a humidi-
fier	as	this	may	cause	electric	shock.
*Do not operate the projector near water such as by the sink or bathtub 
as this may cause electric shock.
 
*Do	 not	block	 or	restrict	 airflow	from	ventilation	 holes	as	this	 may	 cause	
the projector to overheat.
*Do	not	place...

Package Contents
 Projector         Remote Control        Tripod
       Composite A/V Cable       USB Cable
 Power Cord           VGA Cable
3  

Product Overview
Projection Lens
Focus Adjustment
Keypad Controls
Power Button
4
VGA Input
HDMI Input
AV Input
USB Input
Audio Output
SD-HC Card Slot
Power Input  

Keypad  &  Remote  Control  Functions
5
Mute Audio
Menu
Volume Controls
Navigation Controls
Menu
Playback Controls
Power
Keystone Adjustment
Escape
Menu
Playback Controls
Power
Volume ControlsBack
Sources  

General Operation
Turning on the projector
To turn on the projector first plug the power supply into a suitable wall outlet 
and to the rear of the projector.  Then power the projector on by holding the 
power button for 3 seconds until the optical engine turns on.
Shutting down the projector
To shut down the projector, press and hold the power button for 3 sec. The 
optical engine should shut off and the fan should stop spinning.
   Adjusting focus
     To adjust the focus, spin the focus wheel up or...

General Operation
Accessing the Onboard Memory
The OEM-250 Micro Projector includes 
1GB of onboard memory. To access this
memory, connect a USB cable from your
computer to the back of the projector in
the slot that reads “USB”. A folder will
appear on your computer screen after
the projector is detected. You can store any type of supported photos, video 
and/or files in this folder to view.
Note: If your computer fails to detect the projector, check to make sure the 
cable is securely inserted on both...

External Inputs
The OEM-250 micro projector can be toggled to accept different types of 
inputs. This includes VGA (Mini VGA), HDMI and Composite Video (3.5mm 
jack). To toggle through the sources, press the far right button         on touch-
pad or the input button         on the remote control to select the appropriate 
source.
    To Connect to a VGA Source
    The projector can accept a VGA input signal. 
       Connect the VGA cable to your source and  
       the other end should be inserted in the...

External Inputs
            To Connect to a Composite Video Source
             The projector can accept a compositive video 
             signal. This signal is comes through the 3.5mm 
             composite A/V cable. Connect the composite  
             A/V able to the projector and the other end into  
             the video source. Toggle through the input
             sources and once you select AV input, your  
             display should appear.
    
             To Connect to an HDMI Source...