Acer Aspire 1350 Service Guide

Chapter 343
Disassembly Procedure Flowchart
The flowchart on the succeeding page gives you a graphic representation on the entire disassembly sequence 
and instructs you on the components that need to be removed during servicing.  For example, if you want to 
remove the system board, you must first remove the keyboard, then disassemble the inside assembly frame in 
that order.
Start
Battery
HDD Module
Middle Cover
ODD Module F*2
LCD ModuleODD Bracket
Keyboard
Lower Case
Assembly
ODD Tray
Upper Case...

44Chapter 3
  
Screw List
ItemDescription
A SCREW M2.5*4L-BZN-NYLOK
B SCREW M2*3L-NI-NYLOK
C SCREW M2.0*2.0-BZN
D SCREW M2*4L NI-NYLOK
E SCREW M2*7L-NI-NYLOK
F SCREW M2.5*7L-BNI-NYLOK
G SCREW M2.5*3L-BNI-NYLOK
H SCREW M2.5*3L-NI-NYLOK
I SCREW M2.5*5L-NI-NYLOK
J SCREW M2.5*6L-NI-NYLOK
K SCREW M3*2.8L-NI-NYLOK
L SCREW NUT-I/O
4 LCD
Rubbers
J*4
LCD Bezel
Inverter Board
LCDBluetooth
Antenna
LCD Brackets
B*4
LCD Module
J*1
LCD Panel
LCD Coaxial
Cable
J*6
LCD Hook
Bracket
Wireless
AntennaJ*2 J*4 

Chapter 345
Removing the Battery Pack
1.Slide the battery latch.
2.Then remove the battery pack.
 
  

46Chapter 3
Removing the Memory/MDC (Modem/Bluetooth)/HDD Module
1.Remove the two screws holding the DIMM door.
2.Remove the DIMM door.
3.Pop out the memory then take out the memory.
4.Remove the two screws that secure the MDC(modem or modem/Bluetooth combo) board.
5.Remove the MDC board then disconnect  the MDC cable and Bluetooth atenna.
  
6. Remove the two screws holding the HDD bezel(cover).
7.Then pull out the HDD module from the notebook computer.
    

Chapter 347
Removing the Keyboard/ODD Module/FDD Module
1.Remove the right hinge cap.
2.Then remove the left hinge cap.
3.Remove one screw holding the middle cover.
4.Use a flat screwdriver to remove the middle cover carefully.
5.Remove the three screws that hold the keyboard. Then turn over the keyboard.
6.Disconnect the keyboard connector then remove the keyboard.
 
7.Remove the two screws that secure the ODD module.
8.Then take out the ODD module.
  

48Chapter 3
9.Remove the two screws that secure the FDD module.
10.Disconnect the FDD cable.
11 .Then take out the ODD module. 

Chapter 349
Disassembling the Main Unit
1.Remove the four screws that secure the launch board.
2.Then take the launch board off the main unit.
3.Disconnect the lid switch cable.
.
4.Disconnect the wireless LAN antenna.
5.Pop out the wireless LAN card.
6.Disconnect the inverter cable from the main unit.
7.Remove the two screws that secure the LCD coaxial cable.
8.Then disconnect the LCD coaxial cable.
9.Remove the two screws holding the rounting(routing) plate.
10.Then remove the rounting(routing) plate.
. 

50Chapter 3
11 .Pull out the Blustooth antenna carefully.
12.Take out the Bluetooth antenna as picture shows.
13.Remove one screw that secures the ground cable.
.
14.Remove the two screws that secure the LCD module on one side.
15.Then remove another two screws one another side.
16.Detach the entire LCD module.
17.Remove one screw as picture shows in order to detach upper case assembly.
18.Then remove the thirteen screws on the bottom panel.
19.Remove one screw on the rear on one side.
20.Then remove...

Chapter 351
22.Disconnect the touchpad board cable(black) from the main board.
23.Disconnect the touchpad board cable(black) from the touchpad board(scroll board).
24.Disconnect the touchpad cable(white) from the the touchpad board(scroll board).
25.Remove the two screws that secure the touchpad board(scroll board).
26.Then take out the touchpad board(scroll board).
27.Remove the four screws that secure the thermal module according to order.
28.Then remove the thermal module as picture shows....

52Chapter 3
30.Remove the four screws holding the ODD tray.
31.Then remove the ODD tray.
32.Remove the four screws holding the FDD-HDD tray.
33.Then remove the FDD-HDD tray.
34.Disconnect the speaker cable from the main board.
35.Remove the two screws that secure the right and left speakers.
36.Then take out the speakers.
37.Remove the four hexagon screws on the rear as picture shows.
38.Then take out the main board.