1. After properly connecting AEGOP5 to your audio sources and amplifier, plug in AEGOP5’s AC adapter to an AC outlet.
2. Turn on the power of AEGO
P5 by pushing the POWER button on the front panel. Turn on the power of all audio
sources, amplifier, or powered subwoofer.
3. Installation is now complete, get ready to experience true Dolby Digital or DTS surround sound.
Note: To prevent damage to speakers, when playing music or a movie, ensure the volume is set low initially.
Gradually turn the volume up to an appropriate level after the playback has started.
(with 5.1 Theatre System)
Acknowledgments & Trademarks
All contents are subject to change at any time without
notice. No responsibility is assumed for its use; or for
infringements of patents or other rights of third parties
and no patent or license is implied hereby.
All trademarks are the property of their respective
owners. Manufactured under license from Dolby
Laboratories. “Dolby”, “Pro Logic “ and the double-D
symbol are trademarks of Dolby Laboratories.
Confidential Unpublished Works. (c)1992 - 1997
Dolby Laboratories, Inc. All rights reserved.
Manufactured under license from Digital Theater
Systems, Inc. US Pat. No. 5,451,942, 5,956,674, 5,974,380,
5,978,762 and other worldwide patents issued and
pending. “DTS” and “DTS Digital Surround” are
registered trademarks of Digital Theater Systems, Inc.
Copyright 1996, 2000 Digital Theater Systems, Inc.
All Rights Reserved.
FCC Compliance Statement
The equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiver.Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation. Shielded cables and I/O cords must be used for this equipment to comply with
the relevant FCC regulations.
When set to “AUTO”
the Aego system will
go in to standby mode
if no signal is detected
for a period of time
It will automatically
switch back on when
a signal is detected.
This can be altered to
obtain preferred level
This output is available
to supply an auxiliary
subwoofer such as the
Aegis Compact Sub”.
This may be
used in a large room.
This is the main volume
control for all channels.
When used with a
decoder it would
normally be set to
maximum, This enables
the Aego5 system to be
used with DVD players
that have a built in
decoder but no overall
12V DC Left
LINE IN AUX 1 AUX 2Developed And Manufactured By Videologic Systems.
ACOUSTIC ENERGY LIMITED,
16 BRIDGE ROAD, CIRENCESTER,
GLOUCESTERSHIRE GL7 1NJ
Audio Out Audio Out
CD Player VCR Games Consul
Surround Left (SL) Surround Right (SR) Centre Speaker Left Speaker Right Speaker
L Audio Out Digital