© Adam Equipment Company 2014
Manufacturer’s Declaration of Conformity
Adam Equipment Co.
Maidstone Road, Kingston Milton Keynes, MK10 0BD United Kingdom
This product has been manufactured in accordance wi th the harmonised European standards,
following the provisions of the below stated direct ives:
2004/108/EC, Electro Magnetic Compatibility
Directive Standard EN61326-1:2013, Electrical
Equipment for Measurement, Control and
Laboratory Use – EMC requirements – Part 1:
2006/95/EC, Low Voltage Directive
Standard EN61010-1:2010, Safety
requirements for measurement, control and
laboratory use equipment – Part 1: General
2011/65/EC, RoHS, on the Restriction of the
use of certain hazardous substances in
electrical and electronic equipment
2009/23/EC Non Automatic Weighing
Standard EN45501, Applies only to certified
non-automatic weighing instruments
This equipment has been tested and found to comply
with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. The
equipment generates, uses, and can radiate radio fr equency energy and, if not installed and used in
accordance with the instruction manual, may cause h armful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which cas e
the user will be required to correct the interferen ce at his own expense.
Shielded interconnect cables must be employed with this equipment to insure compliance with the
pertinent RF emission limits governing this device.
Changes or modifications not expressly approved by Adam Equipment could void the users authority
to operate the equipment.
DO NOT DISPOSE OF IN GENERAL WASTE
Any Electrical or Electronic Equipment (EEE) compon ent or assembly of parts intended to be
incorporated into EEE devices as defined by Europea n Directive 2012/19/EU must be recycled or
disposed of using techniques that do not introduce hazardous substances harmful to our health or the
environment as listed in Directive 2011/65/EC or am ending legislation.
Battery disposal must be performed according to loc al laws and restrictions.