Addonics Technologies External DigiDrive Flash Reader PU25U3WP4F User Manual

							www.addonics.com
Pocket READ ONLY UDD25,
USB 3.0 / 2.0 
(PU25U3WP-4F)
Technical Support
If you need any assistance to get your unit functioning properly, please have
your product information ready and contact Addonics Technical Support at:
Hours: 8:30 am - 6:00 pm PST
Phone: 408-453-6212
Email: http://www.addonics.com/support/query/ 
						

							1www.addonics.comTechnical Support (M-F 8:30 am – 6:00 pm) 
						

							Overview
Hot Swapping
This unit supports hot swapping (inserting or removing drives while the drives are running
and connected to a computer). When connected using eSATA, the controller on the
computer must also support hot swapping - be sure to confirm this before attempting to
insert or remove drives while the system is running. Also be sure to practice the
appropriate safe removal procedure before proceeding. Failure to practice safe removal
procedures will result in loss or corruption of data.
Write Protect
This unit write protects all media inserted into it. Windows Disk Management will show the
drive as “Read Only” and all attempts to write to the media are blocked, returning a Write
Protect error.
Phone: 408-453-6212Email: www.addonics.com/support/query/    2
USB 3.0 “A to A” Cable 
						

							M.2
3www.addonics.comTechnical Support (M-F 8:30 am – 6:00 pm)
Step 3. Secure the device in place 
with the mounting screw.
Step 2. Insert the media device into 
the NGFF connector at an angle.
Step 1. For 80mm device, remove 
the screw from the 80mm Standoff 
before proceeding. Otherwise, place 
Metal Standoff over mounting hole 
for 30mm, 42mm, or 60mm device.
Note: An extra screw and standoff 
are provided, when installing 60mm 
or 80mm media, remove the extra 
parts. 
						

							mSATA Installation
Phone: 408-453-6212Email: www.addonics.com/support/query/    4
Step 2. Push down the other end 
of the mSATA SSD until it is 
latched securely by the hold 
down clip.
Step 1. Insert the mSATA SSD 
into the mSATA connector on the 
PCB. 
						

							CompactFlash/CFAST Installation
5www.addonics.comTechnical Support (M-F 8:30 am – 6:00 pm)
CompactFlash Adapter
CFAST Adapter
Remove the screws holding the 
adapter in place.
Attach the CompactFlash or 
CFAST Media to the adapter, 
then secure it back in the 
bracket. 
						

							Phone: 408-453-6212Email: www.addonics.com/support/query/    6 
						

							Contact Us
www.addonics.com
Phone: 408-573-8580
Fax: 408-573-8588
Email: http://www.addonics.com/sales/query/