Addonics Technologies USB 31 or 314 SESSIU3CS User Manual

							www.addonics.com
eSATA & USB 3
(SESSIU3CS)
Technical Support
If you need any assistance to get your unit functioning properly, please have
your product information ready and contact Addonics Technical Support at:
Hours: 8:30 am - 6:00 pm PST
Phone: 408-453-6212
Email: http://www.addonics.com/support/query/ 
						

							Overview
1www.addonics.comTechnical Support (M-F 8:30 am – 6:00 pm)
eSATA Cable 
						

							Drive Installation
Hard Disk Installation requires  the 3.5” Bracket is installed reversed, with the Faceplate Notch towards  the
rear  of  the  cabinet.  The  Faceplate  is  secured  in  place  using  the  same  screw  as  the  3.5”  bracket  near  the
front of the cabinet.
Hard Disk Installation: Remove the four screws holding in the 3.5” Bracket and faceplate. Next, mount
the hard disk on the 3.5” bracket in reverse, Connector side on the same side as the Faceplate notch on the
3.5”  Bracket. Align and secure the threads at midpoint on the drive and bracket. Insert the finished bracket
and drive assembly in the Sapphire cabinet, with the brackets faceplate notch to the rear. Insert the Sapphire
Faceplate  by  gently  squeezing  the  ears  together  to  fit  inside  the  3.5”  bracket.  Align  the  3.5”  bracket,
Faceplate, and inner casing holes and secure all three together with the screws.
Phone: 408-453-6212 Email: www.addonics.com/support/query/
    2
Faceplate Notch
(Hard Disk Installation)
Faceplate Mounting ScrewFaceplate
3.5” Bracket
Secure midpoint threads
Connector side of drive