AEG Freestanding fridge freezer S53620CSX2 User Manual

ENUser ManualFridge FreezerS53620CSX2    

CONTENTS
1. SAFETY INFORMATION.................................................................................................3
2.  SAFETY INSTRUCTIONS................................................................................................ 4
3.  OPERATION.................................................................................................................... 5
4.  DAILY...

1.  SAFETY INFORMATION
Before the installation and use of the appliance,carefully read the supplied instructions. The manufacturer is not responsible if an incorrect
installation and use causes injuries and damages. Always keep the instructions with the appliance for future
reference.
1.1  Children and vulnerable people safety
•This appliance can be used by children aged from 8
years and above and persons with reduced physical,sensory or mental capabilities or lack of experienceand knowledge if they have...

•Do not use water spray and steam to clean the
appliance.
• Clean the appliance with a moist soft cloth. Only use
neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects.
• Do not store explosive substances such as aerosol
cans with a flammable propellant in this appliance.
• If the supply cord is damaged, it must be replaced by
the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard.2.  SAFETY INSTRUCTIONS2.1...

• Do not change the specification ofthis appliance.
• Do not put electrical appliances (e.g. ice cream makers) in the applianceunless they are stated applicable bythe manufacturer.
• Be careful not to cause damage to the refrigerant circuit. It contains
isobutane (R600a), a natural gas with a
high level of environmental
compatibility. This gas is flammable.
• If damage occurs to the refrigerant circuit, make sure that there are no
flames and sources of ignition in the
room. Ventilate the room.
• Do not...

A medium setting is
generally the most suitable.
However, the exact setting should be
chosen keeping in mind that the
temperature inside the appliance
depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
If the ambient temperature
is high or the appliance is
fully loaded, and the
appliance is set to the lowest
temperature, it may run
continuously causing frost to
form on the rear wall. In this
case the dial must be set to
a higher...

to remove the typical smell of a brand-new product, then dried thoroughly.CAUTION!
Do not use detergents or abrasive powders, as these
will damage the finish.5.2  Periodic cleaningCAUTION!
Do not pull, move or damage any pipes and/or
cables inside the cabinet.CAUTION!
Take care of not to damage
the cooling system.CAUTION!
When moving the cabinet,
lift it by the front edge to
avoid scratching the floor.
The equipment has to be cleaned
regularly:
1. Clean the inside and accessories with
lukewarm water and...

a basin underneath to collect the
defrost water.
In order to speed up the defrosting
process, place a pot of warm water in the freezer compartment. In addition,remove pieces of ice that break away
before defrosting is complete.
4. When defrosting is completed, dry
the interior thoroughly and keep the
scraper for future use.
5. Switch on the appliance.
After three hours reload the previously
removed food into the freezer
compartment.5.5  Periods of non-operation
When the appliance is not in use for long...

ProblemPossible causeSolutionFood products prevent that
water flows into the water
collector.Make sure that food products
do not touch the rear plate.Water flows on the floor.The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.Attach the melting water out-
let to the evaporative tray.The temperature in the ap-
pliance is too low/too high.The temperature regulator
is not set correctly.Set a higher/lower tempera-
ture.The food products' temper-
ature is too...

•A - green and yellow: Earth
• C - brown: Live
• D - blue: Neutral
As the colours of the wires in the mains
lead of this appliance may not
correspond with the coloured markings
identifying the terminals in your plug,
proceed as follows:
1. Connect the wire coloured green and
yellow to the terminal marked either
with the letter “E“ or by the earth
symbol 
 or coloured green and
yellow.
2. Connect the wire coloured blue to
the terminal either marked with the
letter “N“ or coloured black.
3. Connect the...