AEG Freestanding refrigerator S74010KDX0 User Manual

7.3 Periods of non-operation
When the appliance is not in use for
long periods, take the following precau-
tions:
1.disconnect the appliance from elec-
tricity supply
2.remove all food
3.defrost and clean the appliance and
all accessories
4.leave the door/doors open to pre-
vent unpleasant smells.
If the cabinet will be kept on, ask
somebody to check it once in a
while to prevent the food inside
from spoiling in case of a power
failure.
8. WHAT TO DO IF…
During operation of the appliance some
smaller but...

ProblemPossible causeSolution
 The door is not closed
correctly.Refer to "Closing the
door".
 The door has been
opened too frequently.Do not keep the door
open longer than necessa-
ry.
 The food temperature is
too high.Let the food temperature
decrease to room temper-
ature before storage.
 The room temperature is
too high.Decrease the room tem-
perature.
Water flows inside
the refrigerator.The water outlet is clog-
ged.Clean the water outlet.
 Food prevent that water
flows into the water col-...

ProblemPossible causeSolution
The lamp does not
work.The lamp is defective.Refer to "Replacing the
lamp".
 The door has been open
to long.Close the door.
Door interferes with
ventilation grill.The appliance is not lev-
elled.Refer to "Levelling".
Misaligned door.The appliance is not lev-
elled.Refer to "Levelling".
As much as the advice does not lead to
result, call the nearest brand-mark serv-
ice.
8.1 Replacing the lamp
The appliance is equipped with a long-
life LED interior...

should not be positioned below over-
hanging wall units. Accurate levelling is
ensured by one or more adjustable feet
at the base of the cabinet.
WARNING!
It must be possible to disconnect
the appliance from the mains
power supply; the plug must
therefore be easily accessible af-
ter installation.
9.3 Electrical Connection
CAUTION!
Any electrical work required to
install this appliance should be
carried out by a qualified electri-
cian or competent person.
WARNING!
This appliance must be earthed.
The...

4.Tighten again the screws.
9.5 Levelling
When placing the appliance ensure that
it stands level. This can be achieved by
two adjustable feet at the bottom in
front.
9.6 Removing the shelf
holders
A
B
C
Your appliance is equipped with shelf re-
tainers that make it possible to secure
the shelves during transportation.
To remove them proceed as follows:
1.Move the shelf holders in the direc-
tion of the arrow (A).
2.Raise the shelf from the rear and
push it forward until it is freed (B).
3.Remove the...

• Refit and screw both lower hinges.
• Refit the plinth (8).
•
5
4
• Remove the handle. Unscrew the top
handle bracket from the handle rod
(1). Unscrew the bottom handle brack-
et from the door (2)
• Unscrew the top handle bracket from
the door (3).
• Re-screw the handle bracket on the
door (4). Turn the handle bracket with
the handle and screw them to the
door (5) and the fitted handle bracket
(6)
• Re-insert the door on the lower hinge
pivot .
• Re-insert the door on the upper hinge
pivot slightly...

11. ENVIRONMENT CONCERNS
Recycle the materials with the
symbol  . Put the packaging in
applicable containers to recycle it.
Help protect the environment and
human health and to recycle waste
of electrical and electronicappliances. Do not dispose
appliances marked with the symbol with the household waste. Return the
product to your local recycling
facility or contact your municipal
office.
(1*/,6+17 

18www.aeg.com 

(1*/,6+19 

www.aeg.com/shop
280152609-A-412013