AEG Freestanding washer dryer L75670NWD User Manual

ProblemPossible solution Set the drain or the spin programme if there is water in the
drum.Make sure that the appliance receives electrical power.This problem may be caused by a failure of the appliance.
Contact the Authorised Service Centre. If you need to open
the door, please read carefully «Emergency door opening».The appliance makes an
unusual noise.Make sure the levelling of the appliance is correct. Refer to 'In-
stallation'. Make sure that the packaging and/or the transit bolts are re-...

After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.15.3  Emergency door opening
In case of power failure or functioning failure the appliance door remainslocked. The washing programme
continues when the power is restored. If
the door remains locked in...

Water supply pressure1)Minimum
Maximum0,5 bar (0,05 MPa)
8 bar (0,8 MPa)Maximum wash loadCotton7 kgMaximum dry loadCotton
Synthetics4 kg
2 kgSpin SpeedMaximum1600 rpm1)  The appliance works correctly if the water pressure is not lower than 0.05 MPa (0.5 bar). If you cannot
connect the water inlet hose to the cold water tap of the primary hydraulic system, connect it to your
domestic cold water storage system. Make sure not to exceed a distance of 5.02 m (16.5 ft) between the
appliance inlet hose and the...

www.aeg.com34 

ENGLISH35 

www.aeg.com/shop132947600-A-022016