Home > AEG > Washer/Dryer > AEG Freestanding washer dryer L99695HWD User Manual

AEG Freestanding washer dryer L99695HWD User Manual

    Download as PDF Print this page Share this page

    Have a look at the manual AEG Freestanding washer dryer L99695HWD User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 513 AEG manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							17.5 Positioning and levelling• Install the appliance on a flat hard floor.
    • Make sure that carpets do not stop the air circulation below the appliance.
    • Make sure that the appliance does not touch the wall or other units.
    • Loosen or tighten the feet to adjust the level.
    A correct adjustment of the appliance level
    prevents the vibration, noise and the
    movement of the appliance when in
    operation.• The appliance must be level and stable.CAUTION!
    Do not put cardboard, wood
    or equivalent materials below
    the appliance feet to adjust
    the level.17.6  The inlet hose• Connect the hose to the back appliance.
    Turn the inlet hose only left or right.
    • Loose the ring nut to set it in the correct position.ENGLISH41x4   20O20O45
    O45O  
    						
    							• Connect the water inlet hose to the coldwater tap with 3/4 thread.CAUTION!
    Make sure that there are no leaks from the couplings.Do not use an extension hose if the inlet hose is too short. Contact the service centre for the replacement of the inlet hose.17.7  Water-stop deviceThe inlet hose has a water stop device. This
    device prevents water leaks in the hose
    because of its natural ageing.
    The red sector in the window « A» shows this
    fault.
    If this occur, close the water tap and contact
    the service centre to replace the hose.17.8  Water drainageThere are different procedures to connect the drain hose:With the plastic hose guide:• Making an U form with the drain hose.On the edge of a sink
    • Make sure that the plastic guide cannot move when the appliance drains. Attach
    the guide to the water tap or the wall.www.aeg.com42   A    
    						
    							To a stand pipe with vent-hole
    • Directly into a drain pipe at a height of not less than 60 cm (23.6”) and not more than100 cm (39.3”). Refer to the illustration.
    • The end of the drain hose must always be ventilated , i.e. the inner diameter of the
    drain pipe (min. 38 mm - min. 1.5”) must
    be larger than the external diameter of the
    drain hose.Drain hose end
    • If the end of the drain hose looks like this (see the picture), you can push it directly
    into the stand pipe.Without the plastic hose guide.To a sink spigot
    • Refer to the illustration. Put the drain hose in the spigot and tighten it with a clip.
    • Make sure that the drain hose makes a loop to prevent that remaining particles
    go in the appliance from the sink.To a wall-pipe
    • Directly to a built-in drain pipe in the room wall and tighten it with a clip.You can extend the drain hose to maximum 400 cm. Contact the service
    centre for the other drain hose and the extension.18.  TECHNICAL DATADimensionWidth/ Height/ Depth/ Total depth600 mm/ 870 mm/
    605 mm/ 640 mmENGLISH43      
    						
    							Electrical connectionVoltage
    Overall power
    Fuse
    Frequency230-240 V
    2200 W
    13 A
    50 HzLevel of protection against ingress of solid particles and moisture
    ensured by the protective cover, except where the low voltage
    equipment has no protection against moistureIPX4Water supply 1)Cold waterWater supply pressure2)Minimum
    Maximum0,5 bar (0,05 MPa)
    8 bar (0,8 MPa)Ambient temperatureMinimum5 °CMaximum35 °CMaximum wash loadCotton9Synthetics4Wool1.5Maximum dry loadCotton6Synthetics4 Wool1Spin SpeedMaximum1600 rpm1)  Connect the water inlet hose to a water tap with a 3/4'' thread.
    2)  The appliance works correctly if the water pressure is not less than 0.05 MPa (0.5 bar). If you can not
    connect the water inlet hose to the cold water tap of the primary hydraulic system, connect it to your
    domestic cold water storage system. Make sure not to have more than a distance of 5.02 m (16.5 ft) be- tween the appliance inlet hose and the bottom of the water storage tank.19.  ENVIRONMENT CONCERNSRecycle the materials with the symbol .
    Put the packaging in applicable
    containers to recycle it. Help protect the
    environment and human health and to recycle waste of electrical and electronic
    appliances. Do not dispose appliancesmarked with the symbol  with the
    household waste. Return the product to
    your local recycling facility or contact
    your municipal office.
    *
    www.aeg.com44   
    						
    							ENGLISH45 
    						
    							ENGLISH47 
    						
    							www.aeg.com/shop132908861-A-202014    
    						
    All AEG manuals Comments (0)

    Related Manuals for AEG Freestanding washer dryer L99695HWD User Manual