Home > AEG > Hub > AEG Gas hob HG795440NB User Manual

AEG Gas hob HG795440NB User Manual

Here you can view all the pages of manual AEG Gas hob HG795440NB User Manual. The AEG manuals for Hub are available online for free. You can easily download all the documents as PDF.

Page 11

6.3 Cleaning the hob
• Remove immediately:  melted plastic,
plastic foil, sugar and food with sugar. If not, the dirt can cause damage to
the hob. Take care to avoid burns.
• Remove when the hob is sufficiently
cool:  limescale rings, water rings, fat
stains, shiny metallic discoloration.
Clean the hob with a moist cloth and
non-abrasive detergent. After
cleaning, wipe the hob dry with a soft
cloth.
• To clean the enamelled parts, cap
and crown, wash them with warm
soapy water and dry them carefully...

Page 12

conditions of guarantee are in the
guarantee booklet.7.3  Labels supplied with the
accessories bag
Stick the adhesive labels as indicated below:
A. Stick it on Guarantee Card and send
this part (if applicable).
B. Stick it on Guarantee Card and keep
this part (if applicable).C. Stick it on instruction booklet.8.  INSTALLATIONWARNING!
Refer to Safety chapters.8.1  Before the installation
Before you install the hob, write down
the information bellow from the rating
plate. The rating plate is on the bottom...

Page 13

The hob should not be installed in a bedsitting room with a volume of less than20 m³. If it is installed in a room of
volume less than 5 m³ an air vent of
effective area of 100 cm² is required. If it
is installed in a room of volume between
5 m³ and 10 m³ an air vent of effective area of 50 cm² is required, while if the
volume exceeds 11 m³ no air vent is
required.
However, if the room has a door which
opens directly to the outside no air vent
is required even if the volume is between
5 m³ and 11 m³.
If...

Page 14

CAUTION!
Make sure that the gas
supply pressure of the
appliance obeys the
recommended values.Rigid connection:
Carry out connection by using metal rigid
pipes (copper with mechanical end).
8.4  Injectors replacement
1.Remove the pan supports.
2. Remove the caps and crowns of the
burner.
3. With a socket spanner 7 remove the
injectors and replace them with the
ones which are necessary for the type of gas you use (see table in
"Technical Information" chapter).
4. Assemble the parts, follow the...

Page 15

• or E — Earth terminal
Before carrying out the connection,
make sure:
1. The limiter valve and the electrical
system can take the appliance load
(see the rating plate)
2. The supply system is equipped with
an efficient earth connection in
compliance with the current
standards and regulations
3. The outlet or omnipolar switch used
for connection is easily accessible
with the appliance installed.
The appliance is supplied with a 3 core
flexible power cable with a 3 amp plug. If
it is necessary to change...

Page 16

8.8 Assembly
1.
2.
3.
4.
If a furniture unit is
installed at a distance of
400 mm above the hob,
there must be a
minimum safety distance
of 50 mm to the left or
right from the edge of
the hob.
5.
6.
7.
8.9  Possibilities for insertion
The panel installed below the hob must
be easy to remove and let an easy access
in case a technical assistance
intervention is necessary.
www.aeg.com16  min. 55 mm
min. 650 mm
560 mm
min. 150 mm
30 mm4
80 
mm
min. 600 mm 50 mm400 mm   B
A   

Page 17

Kitchen unit with door or drawerA.Removable panel
B. Space for connectionsKitchen unit with oven
The electrical connection of the hob and
the oven must be installed separately for
safety reasons and to let easy remove
oven from the unit.
9.  TECHNICAL DATA9.1  Hob dimensionsWidth740 mmDepth510 mm9.2 Bypass diametersBURNERØ BYPASS 1/100 mmTriple Crown56Semi-rapid32Auxiliary289.3 Other technical data
TOTAL POWER:
Gas original:G20 (2H) 20 mbar = 10,5 kWGas replacement:G30 (3+) 28-30 mbar = 763 g/h
G31 (3+)...

Page 18

Gas connection:R 1/2" Appliance class:3 9.4 Gas burners for NATURAL GAS G20 20 mbarBURNERNORMAL POWER kWMINIMUM POWER
kWINJECTOR MARK
1/100 mmTriple Crown3,81,4146Semi-rapid1,90,4596Auxiliary1,00,33709.5  Gas burners for LPG G30/G31 28-30/37 mbarBURNERNORMAL
POWER kWMINIMUM
POWER kWINJECTOR
MARK 1/100
mmNOMINAL GAS FLOW g/hG30 28-30
mbarG31 37 mbarTriple Crown3,81,498276271Semi-rapid1,90,4571138136Auxiliary1,00,3350737110.  ENERGY EFFICIENCY10.1  Product information according to EU 66/2014Model...

Page 19

• Use cookware with diameters applicable to the size of burners.• Center the pot on the burner.
• When you heat up water, use only the amount you need.
• If it is possible, always put the lids on the cookware.
• When the liquid starts to boil, turn down the flame to barely simmer the liquid.
• If it is possible, use a pressure cooker. Refer to its user manual.11.  ELECTROLUX / AEG MAJOR APPLIANCES -
WARRANTY CONDITIONSFor domestic use only.
Not for commercial or industrial use. Any alteration or...

Page 20

authorised service agent from who
proof of installation will be required.
8. Repairs carried out under warranty
have a guarantee period of 3 (three) months on the parts and labour
supplied to repair the unit and does
not extend the warranty nor does it
start a new warranty. Parts removed
during guarantee repairs become the
property of Electrolux.
9. After expiry of 6 (six) months from the
date of purchase the warranty shall
be available only to the original retail
purchaser of Electrolux domestic...
Start reading AEG Gas hob HG795440NB User Manual

Related Manuals for AEG Gas hob HG795440NB User Manual

All AEG manuals