AEG Heat pump dryer T76385AH3 User Manual

ProgrammesLoad 1)Properties / Fabric mark
Easy Iron1 kg (or 5shirts)
Easy care fabrics for which a minimum of ironing
is necessary. The drying results can be different
from one type of fabric to the other. Shake the
items before you put them in the appliance.
When the programme is completed, Immediate-
ly remove the items and put them on a hanger.
/ 
  
Active Wear2 kg
To dry outdoor pieces of clothing, technical,
sports, pile fabrics, waterproof and breathable
jackets, shell jacket teamed with a...

 OptionsProgrammes 1)Dry PlusReversePlusAnticreaseTime Dry- ingCottons; Cupboard Dry +  Cottons; Cupboard Dry   Cottons; Iron Dry  Jeans  Bed Linen  Duvets   Time Drying  Synthetics; Extra Dry Synthetics; Cupboard Dry Synthetics; Iron Dry Easy Iron Active Wear  Silk/Lingerie  Wool   2)Extra Quick Mixed  1) Together with the programme you can set 1 or more options.
2)  Only with the drying rack — see chapter ACCESSORIES.6.2  Consumption DataProgrammeSpun at / residual humidityDrying timeEnergy
consump-...

ProgrammeSpun at / residual humidityDrying timeEnergy
consump- tionSynthetics 3,5 kgCupboard Dry1200 rpm / 40%57 min.0,64 kWh 800 rpm / 50%65 min.0,72 kWh7.  OPTIONS7.1  Dry Plus
This option helps to get the laundry
more dried. There are 3 possible
selections:
 - the default selection which is
related to the programme.
 - the selection to get the laundry
lightly dried.
 - the selection to get the laundry
more dried.
7.2  Reverse Plus
To dry more lightly the sensitive and
temperature sensitive textiles...

• Start a short programme (e.g. 30minutes) with moist laundry.At the beginning of drying
cycle (3-5 min.) there could
be a slightly higher sound
level. It is because of start of
the compressor that is
normal for compressor
powered appliances such:
refrigerators, freezers.9.  DAILY USE9.1  Preparing the laundry
• Close the zippers.
• Close the fasteners of the duvet covers.
• Do not keep ties or ribbons loose (e.g. apron ribbons). Tie them before
you start a programme.
• Remove all items from the pockets....

• if the Start/Pause button was notpushed in the time of 5 minutes.
• after 5 minutes from the programme end.
Push the On/Off button to activate the appliance.
If the appliance is on, some indications come in to the view on the display.9.5  Setting a programme
Use the programme dial to set the
programme.
The possible time to complete the
programme comes into the view on the display.
The drying time you see is
related to the load of 5 kg
for cotton and jeans
programmes. For the other
programmes the drying...

9.10 Programme endClean the filter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
If the drying cycle is completed, the
symbol 
flashes on the display. If the
Buzzer option is on, the acoustic signal
sounds intermittently for 1 minute.
If you do not turn off the
appliance, the crease guard
phase starts. Laundry can be
removed during this phase.
To remove the laundry:
1. Push the On/Off button for 2
seconds to turn off the appliance.
2. Open the appliance door.
3....

11. CARE AND CLEANING11.1  Cleaning the filter
At the end of each cycle the indicator 
Filter  is on and you must clean the filter.The filter collects the fluff.
The fluff occurs while the
cloths are dried in the
tumble dryer.
1. Open the door. Pull the filter.
2.Push the hook to open the filter.
3.Use a moist hand to clean both parts
of the filter.
4. If necessary clean the filter with the
brush under warm tap water and/or a
vacuum cleaner. Close the filter.
5. If necessary remove fluff from the
filter...

2.Move the plastic connection out and
drain the water into a basin or
equivalent receptacle.
3. Move plastic connection in and install
water container.
4. To continue the programme press
the Start/Pause button.
11.3  Cleaning the heat
exchanger
If the indicator  Condenser flashes, do
the inspection of the heat exchanger and
its compartment. If there is a dirt, clean
it.
To do the inspection:
1. Open the door. Pull the filter.
2.Move the release button on the
bottom of the door to open the heat
exchanger...

6.Close the heat exchanger cover.
7. Lock the blockage until it snaps.
8. Put the filter back.
11.4  Cleaning the drumWARNING!
Disconnect the appliance
before you clean it.
Use a standard neutral soap detergent to
clean the inner surface of the drum and
drum ribs. Dry the cleaned surfaces with
a soft cloth.CAUTION!
Do not use abrasive
materials or steel wool to
clean the drum.11.5  Cleaning the control
panel and housing
Use a standard neutral soap detergent to clean the control panel and housing.
Use a...

Problem 1)Possible causeRemedy
Unsatisfactory
drying result.
Incorrect programme selection.Do the selection of the applicable
programme. 2)The filter is clogged.Clean the filter. 3)The Dry Plus option was in mini-
mum level. 4)Change the Dry Plus option to the
moderate or maximum level. 4)Too high volume of the load.Obey the maximum load volume.The airflow grill is clogged.Clean the airflow grill in the bot-
tom of the appliance.Dirt on the humidity sensor in the
drum.Clean the front surface of the...