AEG Integrated refrigerator SKS58200F0 User Manual

							If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food
inside from spoiling in case of a power failure.
WHAT TO DO IF…
WARNING!
Before troubleshooting, disconnect the mains plug from the mains socket.
Only a qualified electrician or competent person must do the troubleshooting that is not in
this manual.
There are some sounds during normal use (compressor, refrigerant circulation).
ProblemPossible causeSolution
The appliance does not
operate. The lamp does
not operate.The appliance is switched off.Switch on the appliance.
 The mains plug is not connected
to the mains socket correctly.Connect the mains plug to the
mains socket correctly.
 The appliance has no power.
There is no voltage in the mains
socket.Connect a different electrical ap-
pliance to the mains socket.
Contact a qualified electrician.
The lamp does not work.The lamp is in stand-by.Close and open the door.
 The lamp is defective.Refer to Replacing the lamp.
The compressor operates
continually.The temperature is not set cor-
rectly.Set a higher temperature.
 The door is not closed correctly.Refer to Closing the door.
 The door has been opened too
frequently.Do not keep the door open longer
than necessary.
 The product temperature is too
high.Let the product temperature de-
crease to room temperature be-
fore storage.
 The room temperature is too
high.Decrease the room temperature.
Water flows on the rear
plate of the refrigerator.During the automatic defrosting
process, frost defrosts on the
rear plate.This is correct.
Water flows into the re-
frigerator.The water outlet is clogged.Clean the water outlet.
 Products prevent that water
flows into the water collector.Make sure that products do not
touch the rear plate.
Water flows on the
ground.There is too much water in the
air deflector.Clean the air deflector.
What to do if…11 
						

							ProblemPossible causeSolution
The temperature in the
appliance is too low.The temperature regulator is not
set correctly.Set a higher temperature.
The temperature in the
appliance is too high.The temperature regulator is not
set correctly.Set a lower temperature.
 The door is not closed correctly.Refer to Closing the door.
 The product temperature is too
high.Let the product temperature de-
crease to room temperature be-
fore storage.
 Many products are stored at the
same time.Store less products at the same
time.
 There is no cold air circulation in
the appliance.Make sure that there is cold air
circulation in the appliance.
Replacing the lamp
1. Disconnect the mains plug from the mains socket.
2. Remove the screw from the lamp cover.
3. Remove the lamp cover (refer to the illus-
tration).
4. Replace the used lamp with a new lamp
of the same power and specifically de-
signed for household appliances. (the
maximum power is shown on the lamp
cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the mains plug to the mains socket.
8. Open the door. Make sure that the lamp comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to Installation.
3. If necessary, replace the defective door gaskets. Contact the Service Center.
12What to do if… 
						

							TECHNICAL DATA
   
Dimension  
 Height815 mm
 Width596 mm
 Depth550 mm
Voltage 230-240 V
Frequency 50 Hz
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
WARNING!
Read the Safety Information carefully for your safety and correct operation of the appli-
ance before installing the appliance.
Positioning
This appliance can be installed in a dry, well ventilated indoor (garage or cellar) also, but for
optimum performance install this appliance at a location where the ambient temperature
corresponds to the climate class indicated on the rating plate of the appliance:
Climate classAmbient temperature
SN+10°C to + 32°C
N+16°C to + 32°C
ST+16°C to + 38°C
T+16°C to + 43°C
Electrical Connection
CAUTION!
Any electrical work required to install this appliance should be carried out by a qualified
electrician or competent person.
WARNING!
This appliance must be earthed.
The manufacturer declines any liability should these safety measures not be observed.Technical data
13 
						

							12
3
4
5
The wires in the mains lead are coloured in accordance with the following code:
1Green and Yellow: Earth
3Brown: Live
5Blue: Neutral
As the colours of the wires in the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:
1. Connect the wire coloured green and yellow to the terminal marked either with the let-
ter “E“ or by the earth symbol 
 or coloured green and yellow.
2. Connect the wire coloured blue to the terminal either marked with the letter “N“ or
coloured black.
3. Connect the wire coloured brown to the terminal either marked with the “L“ or col-
oured red.
4.
Check that no cut, or stray strands of wire is present and the cord clamp 
4 is secure
over the outer sheath.
5. Make sure the electricity supply voltage is the same as that indicated on the appliance
rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp plug fitted 
2 . In the event of having to change
the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used.
WARNING!
A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that it
is disposed of safely.
14Installation 
						

							NOISES
There are some sounds during normal running (compressor, refrigerant circulation).
BRRR! HISSS!
CLICK!
BLUBB!
CRACK!
SSSRRR!
OK
CLICK!CLICK!
BRRR!
BRRR!
BLUBB!BLUBB!
Noises15 
						

							HISSS!
HISSS!
SSSRRR!SSSRRR!
CRACK!
CRACK!
ENVIRONMENTAL CONCERNS
The symbol  on the product or on its packaging indicates that this product may not be
treated as household waste. Instead it should be taken to the appropriate collection point
for the recycling of electrical and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential negative consequences for the
environment and human health, which could otherwise be caused by inappropriate waste
handling of this product. For more detailed information about recycling of this product,
please contact your local council, your household waste disposal service or the shop where
you purchased the product.
16Environmental concerns 
						

							17 
						

							18 
						

							19 
						

							www.aeg.com/shop211621369-052011