AEG Integrated refrigerator SKS58210F1 User Manual

ENUser ManualRefrigeratorSKS58210F1    

CONTENTS
1. SAFETY INFORMATION.................................................................................................3
2.  SAFETY INSTRUCTIONS................................................................................................ 4
3.  OPERATION.................................................................................................................... 5
4.  FIRST...

1.  SAFETY INFORMATION
Before the installation and use of the appliance,carefully read the supplied instructions. The manufacturer is not responsible for any injuries ordamages that are the result of incorrect installation or
usage. Always keep the instructions in a safe and
accessible location for future reference.
1.1  Children and vulnerable people safety
•This appliance can be used by children aged 8 years
and above and by persons with reduced capabilities
provided that they have been given...

•Do not use water spray and steam to clean the
appliance.
• Clean the appliance with a moist soft cloth. Only use
neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects.
• Do not store explosive substances such as aerosol
cans with a flammable propellant in this appliance.
• If the supply cord is damaged, it must be replaced by
the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard.2.  SAFETY INSTRUCTIONS2.1...

• Do not change the specification ofthis appliance.
• Do not put electrical appliances (e.g. ice cream makers) in the applianceunless they are stated applicable bythe manufacturer.
• Be careful not to cause damage to the refrigerant circuit. It contains
isobutane (R600a), a natural gas with a
high level of environmental
compatibility. This gas is flammable.
• If damage occurs to the refrigerant circuit, make sure that there are no
flames and sources of ignition in the
room. Ventilate the room.
• Do not...

1.Turn the Temperature regulator
toward lower settings to obtain the minimum coldness.
2. Turn the Temperature regulator
toward higher settings to obtain the
maximum coldness.CAUTION!
If the ambient temperature
is high or the appliance is
fully loaded, and the
appliance is set to the lowest
temperatures, it may run
continuously causing frost to
form on the rear wall. In this
case the dial must be set to
a higher temperature to
allow automatic defrosting
and therefore reduced
energy consumption.4.  FIRST...

6. HINTS AND TIPS6.1  Normal operating sounds
The following sounds are normal during
operation:
• A faint gurgling and bubbling sound from coils sound when refrigerant is
pumped.
• A whirring and pulsating sound from the compressor when refrigerant ispumped.
• A sudden cracking noise from inside appliance caused by thermic
dilatation (a natural and not
dangerous physical phenomenon).
• A faint click noise from the temperature regulator when the
compressor switches on or off.6.2  Hints for energy saving
•...

CAUTION!
When moving the cabinet,
lift it by the front edge to
avoid scratching the floor.
The equipment has to be cleaned
regularly:
1. Clean the inside and accessories with
lukewarm water and some neutral
soap.
2. Regularly check the door seals and
wipe clean to ensure they are clean
and free from debris.
3. Rinse and dry thoroughly.
4. If accessible, clean the condenser
and the compressor at the back of
the appliance with a brush.
This operation will improve the
performance of the appliance and save...

8. TROUBLESHOOTINGWARNING!
Refer to Safety chapters.8.1  What to do if...ProblemPossible causeSolutionThe appliance does not op-
erate.The appliance is switched
off.Switch on the appliance. The mains plug is not con-
nected to the mains socket
correctly.Connect the mains plug to
the mains socket correctly. There is no voltage in the
mains socket.Connect a different electrical
appliance to the mains sock-
et. Contact a qualified elec-
trician.The appliance is noisy.The appliance is not suppor-
ted...

ProblemPossible causeSolutionWater flows on the floor.The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.Attach the melting water
outlet to the evaporative
tray.The temperature in the ap-
pliance is too low/too high.The temperature regulator is
not set correctly.Set a higher/lower tempera-
ture.The door is not closed cor-
rectly.Refer to "Closing the door".The food products' tempera-
ture is too high.Let the food products tem-
perature decrease to room...