AEG Lavamat 62640 User Manual

							Positioning and levelling
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not impeded by carpets,
rugs etc.
Before placing it on small tiles, apply a rubber coating.
Never try to correct any unevenness in the floor by
putting pieces of wood, cardboard or similar
materials under the machine.
If it is impossible to avoid positioning the machine
next to a gas cooker or coal-burning stove, an
insulating panel covered with aluminium foil on the
side facing the cooker or stove, must be inserted
between the two appliances.
The machine must not be installed in rooms where
the temperature can drop below 0.
The water inlet hose and the drain hose must not be kinked.
Please ensure that when the appliance is installed, it is easily accessible for the
engineer in the event of a breakdown.
Carefully level by screwing the adjustable feet in or out. Never place cardboard,
wood or similar materials under the machine to compensate for any unevenness
in the floor.
Water inlet
An inlet hose is supplied and can be found inside the machine drum.
Do not use the already employed hoses to connect to the water supply.
This appliance must be connected to a cold water supply.
1.Open the porthole and extract the inlet hose.
2.Connect the hose with the angled connection to
the machine.
Do not place the inlet hose downwards. Angle
the hose to the left or right depending on the
position of your water tap.
41Installation
	

	

192998381 gb.qxd  9/8/2008  10:14 AM  Page 41
 
						

							3.Set the hose correctly by loosening the ring nut.
After positioning the inlet hose, be sure to tighten
the ring nut again to prevent leaks.
4.Connect the hose to a tap with a 3/4” thread.
Always use the hose supplied with the appliance.
Installation should comply with local water authority
and building regulations requirements. A minimum
water pressure of 0.05 MPa is required for safe
operation of the appliance.
If you cannot make the cold water connection direct from the rising mains, you
may be able to operate the appliance from your cold water storage system. There
should be a minimum distance of between the appliance’s inlet and the bottom of
the water storage tank.
Water drainage
The end of the drain hose can be positioned in three
ways:
Hooked over the edge of a sink using the
plastic hose guide supplied with the machine.
In this case, make sure the end cannot come
unhooked when the machine is emptying.
This could be done by tying it to the tap with a piece
of string or attaching it to the wall.
In a sink drain pipe branch. This branch must be above the trap so that the bend
is at least 60 cm above the ground.
Directly into a drain pipe at a heightof not less than 60 cm and not more
than 90 cm.
The end of the drain hose must always be ventilated, i.e. the inside diameter of
the drain pipe must be larger than the outside diameter of the drain hose.
The drain hose must not be kinked.
42Installation
192998381 gb.qxd  9/8/2008  10:14 AM  Page 42
 
						

							Important!
The drain hose may be extended to a maximum of 4 metres. An additional drain hose and
joining piece is available from your local Service Centre.
Electrical connection
This machine is designed to operate on a 220-230 V, single-phase, 
50 Hz supply.
Check that your domestic electrical installation can take the maximum load
required (2.2 kW), also taking into account any other appliances in use.
Connect the machine to an earthed socket.
The manufacturer does not accept any responsibility for damage or
injury through failure to comply with the above safety precaution.
Permanent connection
In the case of a permanent connection it is necessary that you install a double pole
switch between the appliance and the electricity supply (mains), with a minimum
gap of 3 mm between the switch contacts and of a type suitable for the required
load in compliance with the current electrical regulations.
The switch must not break the yellow and green earth cable at any point.
This operation must be performed by a qualified electrician.
The power supply cable must be easily accessible after installing the
machine.
Should the appliance power supply cable need to be replaced, this must
be carried out by a Service Centre.
43Installation




192998381 gb.qxd  9/8/2008  10:14 AM  Page 43
 
						

							Enviroment concerns
Packaging materials
The materials marked with the symbol  are recyclable.
>PEPSPP
						

							European Guarantee
This appliance is guaranteed by Electrolux in each of the countries listed at the
back of this user manual, for the period specified in the appliance guarantee
orotherwise by law. If you move from one of these countries to another of the
countries listed, the appliance guarantee will move with you subject to the
following qualifications:
The appliance guarantee starts from the date you first purchased the appliance
which will be evidenced by production of a valid purchase document issued by
the seller of the appliance.
The appliance guarantee is for the same period and to the same extent for
labour and parts as exists in your new country of residence for this particular
model or range of appliances.
The appliance guarantee is personal to the original purchaser of the appliance
and cannot be transferred to another user.
The appliance is installed and used in accordance with instructions issued by
Electrolux and is only used within the home, i.e. is not used for commercial
purposes.
The appliance is installed in accordance with all relevant regulations in force
within your new country of residence.
The provisions of this European Guarantee do not affect any of the rights
granted to you by law.
45European Guarantee
192998381 gb.qxd  9/8/2008  10:14 AM  Page 45
 
						

							46Customer service centres
www.electrolux.com
à
Albania+35 5 4 261 450Rr. Pjeter Bogdani Nr. 7 Tirane
Belgique/België/Belgien+32 2 363 04 44Bergensesteenweg 719, 1502 Lembeek
Česká republika+420 2 61 12 61 12Budějovická 3, Praha 4, 140 21
Danmark+45 70 11 74 00Sjællandsgade 2, 7000 Fredericia
Deutschland+49 180 32 26 622Muggenhofer Str. 135, 90429 Nürnberg
Eesti+37 2 66 50 030Mustamäe tee 24, 10621 Tallinn 
España+34 902 11 63 88Carretera M-300, Km. 29,900 Alcalá de Henares  Madrid
Francewww.electrolux.fr
Great Britain+44 8705 929 929Addington Way, Luton, Bedfordshire LU4 9QQ
Hellas+30 23 10 56 19 704, Limnou Str., 54627 Thessaloniki
Hrvatska+38 51 63 23 338Slavonska avenija 3, 10000 Zagreb
Ireland+353 1 40 90 753Longmile Road Dublin 12
Italia+39 (0) 434 558500C.so Lino Zanussi, 26 - 33080 Porcia (PN)
Latvija+37 17 84 59 34Kr. Barona iela 130/2, LV-1012, Riga
Lituania+370 5 27 80 609Verkiu, 2 9, 09108 Vilnius, Lithuania
Luxembourg+35 2 42 43 13 01Rue de Bitbourg, 7, L-1273 Hamm
Magyarország+36 1 252 1773H-1142 Budapest XIV, Erzsébet királyné útja 87
Nederland+31 17 24 68 300Vennootsweg 1, 2404 CG - Alphen aan den Rijn
Norge+47 81 5 30 222Risløkkvn. 2 , 0508 Oslo
Österreich +43 18 66 400Herziggasse 9, 1230 Wien
Polska+48 22 43 47 300ul. Kolejowa 5/7, Warsaw
Portugal+35 12 14 40 39 39Quinta da Fonte - Edificio Gonçalves Zarco - Q35 -2774-518 Paço de Arcos
Romania+40 21 451 20 30Str. Garii Progresului 2, S4, 040671 RO
Schweiz-Suisse-Svizzera+41 62 88 99 111Industriestrasse 10, CH-5506 Mägenwil
Slovenija+38 61 24 25 731Tr aška 132, 1000 Ljubljana
Slovensko+421 2 43 33 43 22Electrolux Slovakia s.r.o., Electrolux Domáce spotrebiče SK, Seberíniho 1, 821 03 Bratislava
Suomiwww.electrolux.fi
Sverige+46 (0)771 76 76 76Electrolux Service, S:t Göransgatan 143, S-105 45 Stockholm
Türkiye+90 21 22 93 10 25Tarlabași caddesi no : 35 Taksim Istanbul
Россия+7 095 937 7837129090Москва, Олимпийский проспект, 16, БЦ «Олимпик»
192998381 gb.qxd  9/8/2008  10:14 AM  Page 46
 
						

							47
192998381 gb.qxd  9/8/2008  10:14 AM  Page 47
 
						

							www.electrolux.com
www.aeg-electrolux.gb
192 998 381-00-362008     Subject to change without notice
192998381 gb.qxd  9/8/2008  10:14 AM  Page 48