AEG Lavamat 84950 A Instruction Booklet

11Use
First Use
Ensure that the electrical and water connections comply with the installation
instructions.
Remove the polystyrene block and  any material from the drum.
Run a cotton cycle at 95°C, without any laundry in the machine, to remove any
manufacturing residue from the drum and tub. Pour 1/2 a measure of detergent
into the dispenser drawer and start the machine.
Setting the language
When switching on the appliance for the first time, by turning the programme
selector dial, you must set the...

12Use
Personalization
This appliance is provided of a «settings» menu that allows you to modify the
factory settings as you want.
When you switch on the machine, by turning the programme selector dial, press
the «OPTIONS» button to activate the Options menu. By pressing again the same
button you can move through all the available options till when you locate the
Settingsmenu. Press OKto access in the menu. Use again «OPTIONS» button to
scroll all the settings and press OKbutton to confirm your choice....

13Use
Daily Use
Load the laundry
1.Open the door by carefully pulling the door handle outwards. Place the
laundry in the drum, one item at a time,
shaking them out as much as possible.
2.Close firmly the door. You must hear a click
during closing.
Attention!Do not embed the laundry
between the door and the rubber joint.
Measure out the detergent and the fabric softener
Your new appliance was designed to reduce
water, energy and detergent consumption.
1.Pull out the dispenser drawer until it
stops....

14Use
Turn the programme selector dial to the required programme. The programme
selector determines the type of washing cycle (e.g. water level, drum movement,
number of rinses) and the washing temperature according to the type of laundry.
The START/PAUSElight starts to flash and the Display shows the programme
name and the duration of the selected programme.
The selector dial can be turned either clockwise or anticlockwise. 
Position 
O/OFFto Reset programme/Switching OFF of the machine.
At the end of...

15Use
«Rinse hold»  :by selecting this option the water of the last rinse is not
emptied out to prevent the fabrics from creasing. At the end of the programme,
0and  -symbol will flash on the display, the messages «Door locked»and
«Rinse hold»appear on the display, the START/PAUSE pilot light goes off and the
door is blocked to indicate that the water must be emptied out.
To empty the water out:
●turn the programme selector dial to O/OFF
●select the DRAIN or SPIN programme
●reduce the spin speed if...

16Use
To scroll all the available options, depress the «OPTIONS» button. The
corresponding programme name appears in the relative rectangle to indicate
that this programme has been selected.
Depress the OKbutton to activate and confirm your choice. The corresponding
icon appears on the right side of the display to indicate that this option has been
set. Depress the same button to deactivate the option.
After selecting the options, wait about 10 seconds untill the display gets back to
the default status....

17Use
Select the EXTRA RINSE option 
This appliance is designed for saving water. However, for people with a very
delicate skin (allergic to detergents) it may be necessary to rinse the laundry
using an extra quantity of water (extra rinse).
For the compatibility between this option and washing programmes consult the
chapter «Washing programmes».
The relevant symbol will appear on the display.
Select the TIME option
The washing machine proposes by default the washing cycle for «Normally soiled
laundry»....

18Use
●by pressing the OPTIONSbutton select the number of the MEMORY (1-2) in
which you wish memorize your customized programme.
●press the Okbutton to save the selected programme. On the display appears
the message «SAVED» in highlighted mode.
To change the memorized programme setting repeat the procedure from the
beginning. 
Note
If the memory space is already used by a programme previously selected, the
display will show the message «Memory full. Press OK to overwrite it. Press
OPTIONS to cancel.»....

19Use
DISPLAY
The display shows the following information:
Duration of the selected programme
After selecting a programme, the duration of the washing programme and the
extimated end of cycle are displayed in hours and minutes (for example 
2.05).
The duration is calculated automatically on the basis of the maximum
recommended load for each type of fabric.
After the programme has started, the time remaining is updated every minute.
Programme progress display
After having pressed the START/PAUSE button,...

If your laundry is not removed during 10 minutes after the programme is
finished, the backlight of the display switches off and the energy saving system
will be enabled.
Only the START/PAUSE button pilot light is flashing to indicate that the appliance
has to be switched off.
By pressing any button the appliance will come out from the energy saving
status and you could set another washing programme or swich off the appliance.
Select the START/PAUSE
Press the Start/Pause button, to start the selected...