AEG Oven BP500352DM User Manual
Have a look at the manual AEG Oven BP500352DM User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 513 AEG manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
The cleaning reminder goes out: • after the end of the Pyrolysis function. • if you press and at the same time while PYR flashes in the display. 10.6 Removing and installing the door You can remove the door and the internal glass panels to clean it. The number of glass panels is different for different models. WARNING! Be careful when you remove the door from the appliance. The door is heavy. 1. Open the door fully. 2. Fully press the clamping levers (A) on the two door hinges. 3. Close the oven door to the first opening position (approximately 70° angle). 4. Hold the door with one hand on each side and pull it away from the appliance at an upwards angle. 5. Put the door with the outer side down on a soft cloth on a stable surface. This is to prevent scratches. 6. Hold the door trim (B) on the top edge of the door at the two sides and push inwards to release the clip seal. 7. Pull the door trim to the front to remove it. 8. Hold the door glass panels on their top edge one by one and pull them up out of the guide. 9. Clean the glass panel with water and soap. Dry the glass panel carefully. When the cleaning is completed, do the above steps in the opposite sequence. Install the smaller panel first, then the larger and the door. WARNING! Make sure that the glasses are inserted in the correct position otherwise the surface of the door may overheat. Make sure that you put the glass panels (C, B and A) back in the correct sequence. First, insert panel C, which has a square printed on the left side and a triangle on the right side. You will also find those symbols embossed on the door frame. The triangle symbol on the glass must match the triangle on the door frame, and the square symbol must match the square. After that insert the other two glass panels. ENGLISH31 AA 1 2 B
10.7 Replacing the lamp Put a cloth on the bottom of the interior of the appliance. It prevents damage to the lamp glass cover and the cavity. WARNING! Danger of electrocution! Disconnect the fuse before you replace the lamp. The lamp and the lamp glass cover can be hot.1. Deactivate the appliance. 2. Remove the fuses from the fuse box or deactivate the circuit breaker.The top lamp 1. Turn the lamp glass cover counterclockwise to remove it. 2. Clean the glass cover. 3. Replace the lamp with a suitable 300 °C heat-resistant lamp. 4. Install the glass cover. 11. TROUBLESHOOTINGWARNING! Refer to Safety chapters.11.1 What to do if...ProblemPossible causeRemedyYou cannot activate or oper- ate the oven.The oven is not connected to an electrical supply or it is connected incorrectly.Check if the oven is correctly connected to the electrical supply (refer to the connec- tion diagram if available).The oven does not heat up.The oven is deactivated.Activate the oven.The oven does not heat up.The clock is not set.Set the clock.The oven does not heat up.The necessary settings are not set.Make sure that the settings are correct.www.aeg.com32A B C
ProblemPossible causeRemedyThe oven does not heat up.The automatic switch-off is activated. Refer to "Automatic switch- off". The oven does not heat up.The Child Lock is on.Refer to "Using the Child Lock".The oven does not heat up.The fuse is blown.Make sure that the fuse is the cause of the malfunction. If the fuse is blown again and again, contact a quali- fied electrician.The lamp does not operate.The lamp is defective.Replace the lamp.It takes too long to cook the dishes or they cook too quickly.The temperature is too low or too high.Adjust the temperature if necessary. Follow the advice in the user manual.Steam and condensation settle on the food and in the cavity of the oven.You left the dish in the oven for too long.Do not leave the dishes in the oven for longer than 15 - 20 minutes after the cooking process ends.The display shows "C3".The cleaning function does not operate. You did not fully close the door, or the door lock is defective.Fully close the door.The display shows "F102".• You did not fully close the door. • The door lock is defec- tive.• Fully close the door. • Deactivate the oven with the house fuse or the safety switch in the fuse box and activate it again. • If the display shows "F102" again, contact the Customer Care Depart- ment.The display shows an error code that is not in this table. There is an electrical fault.• Deactivate the oven with the house fuse or the safety switch in the fuse box and activate it again. • If the display shows the error code again, contact the Customer Care De- partment.There is no good cooking performance using the True Fan Cooking PLUS function.You did not activate the True Fan Cooking PLUS function.Refer to "Activating the True Fan Cooking PLUS func- tion".ENGLISH33
ProblemPossible causeRemedyThere is no good cooking performance using the True Fan Cooking PLUS function.You did not activate correct- ly the True Fan Cooking PLUS function with the Plus Steam button.Refer to "Activating the True Fan Cooking PLUS func- tion".There is no good cooking performance using the True Fan Cooking PLUS function.You did not fill the cavity embossment with water.Refer to "Activating the True Fan Cooking PLUS func- tion".You want to activate the True Fan Cooking function, but the indicator of the Plus Steam button is on.The True Fan Cooking PLUS function operates.Push the Plus Steam button to stop the True Fan Cooking PLUS function. You want to activate the cleaning function, but the display shows "C4".The Plus Steam button is pressed in.Press the Plus Steam button again.The water in the cavity em- bossment does not boil.The temperature is too low.Set the temperature at least to 110 °C. Refer to “Hints and tips” chapter.The water comes out of the cavity embossment.There is too much water in the cavity embossment.Deactivate the oven and make sure that the appliance is cold. Wipe the water with a cloth or sponge. Add the correct amount of water to the cavity embossment. Re- fer to the specific procedure.The appliance is activated and does not heat up. The fan does not operate. The display shows "Demo".The demo mode is activa- ted.1. Deactivate the oven. 2. Press and hold the but- ton . 3. The first digit on the dis- play and Demo indicator start to blink. 4. Enter the code 2468 by pressing the buttons or to change the val- ues and press to con- firm. 5. The next digit starts to blink. 6. Demo mode deactivates when you confirm the last digit and the code is correct. www.aeg.com34
11.2 Service data If you cannot find a solution to the problem yourself, contact your dealer or an Authorised Service Centre. The necessary data for the service centre is on the rating plate. The rating plate ison the front frame of the appliance cavity. Do not remove the rating plate from the appliance cavity.We recommend that you write the data here:Model (MOD.).........................................Product number (PNC).........................................Serial number (S.N.).........................................12. ENERGY EFFICIENCY12.1 Product Fiche and information according to EU 65-66/2014Supplier's nameAEGModel identificationBP500352DMEnergy Efficiency Index81.2Energy efficiency classA+Energy consumption with a standard load, conven- tional mode1.09 kWh/cycleEnergy consumption with a standard load, fan-forced mode0.69 kWh/cycleNumber of cavities1Heat sourceElectricityVolume71 lType of ovenBuilt-In OvenMass39.0 kgEN 60350-1 - Household electric cooking appliances - Part 1: Ranges, ovens, steam ovens and grills - Methods for measuring performance.12.2 Energy savingThe appliance contains features which help you save energy during everyday cooking.General hints Make sure that the oven door is closed properly when the appliance operates and keep it closed as much as possible during the cooking. Use metal dishes to improve energy saving. When possible, do not preheat the oven before you put the food inside. When the cooking duration is longer than 30 minutes, reduce the ovenENGLISH35
temperature to minimum 3 - 10 minutesbefore the end of the cooking time, depending on the duration of the cooking. The residual heat inside the oven will continue to cook. Use the residual heat to warm up other dishes.Cooking with fan When possible, use the cooking functions with fan to save energy. Residual heat If a programme with the Duration or End Time selection is activated and the cooking time is longer than 30 minutes, the heating elements deactivate automatically 10% faster in some oven functions. The fan and lamp continue to operate. Keep food warm Choose the lowest possible temperature setting to use residual heat and keep a meal warm. The display shows the residual heat indicator or temperature.Cooking with the lamp off Deactivate the lamp during cooking and activate only when you need it. Moist Fan Baking Function designed to save energy during cooking. It operates in such a way that the temperature in the oven cavity may differ from the temperature indicated on the display during a cooking cycle and cooking times may be different from the cooking times in other programmes. When you use Moist Fan Baking, the lamp automatically deactivates after 30 seconds. You may activate the lamp again but this action will reduce the expected energy savings. 13. ENVIRONMENTAL CONCERNSRecycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliancesmarked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office. * www.aeg.com36