AGFA AP DC833m User Manual

							
 
56 
 
 ² ² ² ² ² ² ² ² ² ² ² ² ² ² 
 ² ² ² ² ² ² ² ² ² ² ² ² ² ² 
 ² z ² O O O O O z ² ² ² ² ² 
 ² z ² O O O O O z ² ² ² ² ² 
 ² z ² O O O O O z ² ² ² ² ² 
 
² z ² O O O O O z ² ² ² ² ² 
 ² z ² O O O O O z ² ² ² ² ² 
 
² z ² O O O O O z ² ² ² ² ² 
 ² z ² O O O O O z ² ² ² ² ² 
 ² z ² z ² ² ² ² z ² ² ² ² ² 
 
² z ² O O O O O z ² ² ² ² ² 
 ² z ² O O O O O z ² ² ² ² ² 
 ² z ² O O O O O z ² ² ² ² ² 
Scene Mode 
 ² z ² O O O O O z ² ² ² ² ² 
 
² z ² O O O O O z ² ² ² ² ² 
 
² ² ² O O O O O z ² O O O O 
 O O O O O O O O z O O O O O 
Still Capture 
 O O O O O O O O z O O O O O 
 
 O ” O ” O O O O z O ” O O O 
+0.3 ~ +2.0 
0EV 
-0.3 ~ -2.0 
Off 
2 sec. 
10 sec. 
Double 
Burst  Off 
On 
Off 
   
Mode   
 
 
 
 
Function  
MENU 
Exposure Drive Mode  AEB Highlight 
  
						

							
 
57 
 
 ² ² ² ² ² ² ² ² ² ² ² ² ²  ²  ² 
 ² ² ² ² ² ² ² ² ² ² ² ² ²  ²  ² 
 ² z ² z ² ² ² ² ² ² O O O O O 
 z ² ²  z O O O O O O O O O O O 
 ² z ²  z O O O O O O O O O O O 
 
² z ² z ² ² ² ² ² ² O O O O O 
 ² z ² z ² ² ² ² ² ² O O O  z
  ² 
 
² z ² z ² ² ² ² ² ² O O O O O 
 ² z ²  z O O O O O O O O O O O 
 ² z ²  z O O ² O ² ² O O O O O 
 
² z ² z ² ² ² ² ² ² O O O O O 
 z ² ² z ² ² ² ² ² ² O O O O O 
 z ² ²  z O O O O O O O O O O O 
Scene Mode 
 ² z ²  z O O O O O O O O O O O 
 
² z ² z ² ² ² ² ² ² ² ² z O O 
 O O O  z
 O O O O O O O O O O O 
 O O O  z
 O O O O O O O O O O O 
Still Capture 
 O O O  z
 O O O O O O O O O O O 
 
 O ” O  z
 O O O O O O ” O O ” O 
Hard 
Normal 
Soft 
Off 
B&W 
Sepia 
Negative  Red 
Green 
Blue Off 
Date 
Date & Time  Off 
On 
Mode   
 
 
 
Function 
MENU 
Sharpness Effect Date Stamp Stabilizer
  
						

							
 
58 
 
 ² ² ² ² ² ² 
 ² ² ² ² ² ² 
 z ² O O O O 
 z ² O O O O 
 z ² O O O O 
 O O O O O O 
 z ² O O O O 
 
z ² O O O O 
 O O O O O O 
 ² z z ² O O 
 O O O O O O 
 z ² O O O O 
 z ² O O O O 
Scene Mode 
 O O O O O O 
 O O O O z ² 
 O O O O O z 
 O O O O O z 
Still Capture 
 O O O O O z 
 
 
” ² ” O O ” 
Off 
On  Off 
Frame 1 ~ 10  Off 
On 
Mode   
 
 
 
Function 
MENU 
Face Tracking  Photo Frame  Digital Zoom 
”  : Factory setting    z : Default setting    { : Available      ± : Not available. 
: Setting is retained even after mode switch or power off.  : Disable function. 
: Set to  [OFF] after power off. 
  
						

							
 
59 
Customer care   
More information on the complete AgfaPhoto digital camera product range can be found under 
www.plawa.com / www.plawausa.com 
 
Service & Repair (USA/ Canada): 
1-866 475 2605 
www.plawausa.com 
 
Support Service (USA/ Canada): 
[email protected] 
 
Service & Repair Hotline (EU): 
00800 752 921 00 (from a landline only) 
 
Service & Support Hotline (Germany): 
0900 1000 042 (1.49 Euro/ min. from a German landline only) 
 
Online Service / International contact (Not for USA/ Canada): 
[email protected] 
 
 
Manufactured by 
plawa-feinwerktechnik GmbH & Co. KG 
Bleichereistraße 18 
73066 Uhingen 
Germany 
 
 
 
AgfaPhoto is used under license of Agfa-Gevaert NV & Co. KG or Agfa-Gevaert NV.  
Agfa-Gevaert NV & Co. KG. or Agfa-Gevaert NV does not manufacture this product or provide 
any product warranty or support. For service, support and warranty information, contact the 
distributor or manufacturer. Contact: AgfaPhoto Holding GmbH, www.agfaphoto.com   
  
						

							
 
60 
 
Disposal of Waste Equipment by Users in Private Households in 
the European Union 
This symbol on the product or on its packaging indicates that this product must not be 
disposed of with your other household waste. Instead, it is your responsibility to dispose of 
your waste equipment by handing it over to a desi gnated collection point for the recycling of waste 
electrical and electronic equipment. The separate collection and recycling of your\
 waste 
equipment at the time of disposal will help to conserve natural resources and ensure that it is 
recycled in a manner that protects human health  and the environment. For more information about 
where you can drop off your waste equipment for recy cling, please contact your local city office, 
your household waste disposal service or the shop where you purchased the product. 
 
FCC Compliance and Advisory 
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions: 1.) this device may not cause harmful interference, and 2.) this device must accept 
any interference received, including interference that may cause unsatisfactory operation. This 
equipment has been tested and found to comply with the limits for a Class B peripheral, pursuant 
to Part 15 of the FCC Rules. These limits ar e designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment generates, uses, and can radiate 
radio frequency energy and, if not installed and used in accordance with the instructions, may 
cause harmful interference to radio communication. However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by turning the equipment 
off and on, the user is encouraged to try to correct the interference by one or more of the 
following measures. 
 
•   Reorient or relocate the receiving antenna.   
•   Increase the separation between the equipment and receiver.   
•   Connect the equipment to an outlet on a circuit different from that to which the receiver is 
connected. 
•   Consult the dealer or an experienced radio/TV technician for help.   
 
Any changes or modifications not expressly approved by the party responsible for compliance 
could void the user’s authority to operate the equipment. When shielded interface cables have 
been provided with the product or when specif ied additional components or accessories have 
elsewhere been designated to be used with the installation of the product, they must be used in 
order to ensure compliance with FCC regulations.
  
						

							
 
61 
Declaration of Conformity 
We herewith confirm the following designated product: AgfaPhoto digital camera DC-833m has 
been tested and found to comply with the requirements set up in the council directive on the 
approximation of the law of members’ states relating to the EMC Directive 2004/108/EC. For the 
evaluation regarding to the electromagnet compatibility, the following standards were applied: 
 
EN 55022: 2006, Class B   
EN 55024: 1998 + A1: 2001 + A2: 2003 
IEC 61000-4-2: 1995+A1: 1998+A2: 2000 
IEC 61000-4-3: 2002+A1: 2002 
IEC 61000-4-4: 2004 
IEC 61000-4-6: 1996+A1:2000 
IEC 61000-4-8: 1993+A1: 2000 
 
The device is marked with CE logo. 
  
						

							AgfaPhoto is used under license of Agfa-Gevaert NV & Co. KG or Agfa-Gevaert NV. Neither Agfa-Gevaert NV & Co KG nor Agfa-
Gevaert NV manufacture this product or provide any product warranty or support. For service, support and warranty information,
contact the distributor or manufacturer All other brands and product names are registered trademarks of their respective owners.
Product design and technical features can be changed without notice. 
AgfaPhoto Holding GmbH, www.agfaphoto.com
Manufactured by plawa-feinwerktechnik GmbH & Co. KG, www.plawa.com