Home > AGI Security > System > AGI Security System SYSHC0857 How to set up DVR for remote access End User User Manual

AGI Security System SYSHC0857 How to set up DVR for remote access End User User Manual

    Download as PDF Print this page Share this page

    Have a look at the manual AGI Security System SYSHC0857 How to set up DVR for remote access End User User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 85 AGI Security manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							How to set up DVR for remote access (End User) 
    1. Connect your DVR to the router using a network cable. 
     
    2. Get the DVR onto your local network- this is done by: User 
     
    3. Simply type in cmd into your PC 
     
    4. A prompt box will come up  
     
    5. Type in ipconfig and press enter 
     
    6. Note the Gateway address (3rd line), this is the address of your router (shown on the 
    diagram above) 
     
    7. The Gateway needs to be put into the DVR network settings- you may need to change the 
    ip address also. For example if the Gateway is 192.168.1.254 then put this into the DVR 
    Gateway settings. Change the IP address to 192.168.1.X. The X can be anything between 
    0-255 but it cannot conflict with any other device. E.g. when you typed in ipconfig, it 
    would have also told you the IP address of that PC, you CANNOT use this in the DVR. 
    The X represents unique devices on the network, so your PC maybe 192.168.1.10 so 
    you’re DVR could be 192.168.1.11 but it cannot conflict. 
     
    Similarly if the Gateway is 192.168.0.1 then this should become the Gateway of the DVR, as the 
    PC and DVR share the same home or router. But here the IP adddress would become 
    192.168.0.X. you can see the first 3 batches must be the same. 
     
    8. Now that you have got the DVR to connect locally, we are ready for the final step. 
     
    9. Find out the ports the DVR uses, for example AVTECH uses port 80 (TCP). This needs 
    to be forwarded to the DVR. How do I do this? This depends on the router you have, 
    there are thousands of routers, so each setting will be different! (just to make it even more 
    complicated).any question contact Router manufacture for support.  
     
    10. We recommend a website called www.portforward.com where you can select your router 
    and it will give you a FREE guide on how to set it up. 
     
    11. Find out your IP address by going on www.whatismyip.com This is the address of your 
    internet and is unique to your property. (Note anything with 192.168 is a local address, 
    for internal only) 
     
    12.  Heres a video we have found on youtube (not relevant for our DVRs but gives you an 
    example) 
      
    						
    							13. How to Setup a CCTV DVR for remote viewing online by PC Mac & smart phone 
    internet Access 8517022012, See YouTube video below.  
     
    https://www.youtube.com/watch?v=tg8wEzJOf9o&feature=player_embedded 
     
     
      
    						
    All AGI Security manuals Comments (0)

    Related Manuals for AGI Security System SYSHC0857 How to set up DVR for remote access End User User Manual