Home > Aimco Brakes > AcraDyne > Aimco Brakes AcraDyne ErgoArms Operations Manual

Aimco Brakes AcraDyne ErgoArms Operations Manual

View the Aimco Brakes AcraDyne ErgoArms Operations Manual for free. All the Aimco Brakes manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

Overview View all the pages Comments

$Page 1 PO Box 1\f4\f0, Portland OR 97\b9\b-04\f0 • 800-85\b-13\f8 • Fax 800-58\b-9015www.aimco-global.com ERGO-ARM Tool Support Systems Operations Manual MODELS AD-D1098S/SAC& AD-D1098P/PAC Ergo Arm Operations \:Manual_3000 nutrunner\: manual.qxd \f/\b/2013\: \f:46 AM Page 1$

$Page 2 I N T R O D U C T I O N 2 CAUTION! Please read the following manual before assembling and operating your ErgoArm Tool Support System\b As in all cases, when electric or air lines come in close contact with moving parts or mechanisms, precautions should be taken by the person installing and operating the equipment that these cords or hoses do not become entangled or damaged by moving parts\b Proper attention will prevent possible hazard or injury. R E C O M M E N D E D T O O L S \b...$

$Page 3 3 I N S T A L L A T I O N A N D S E T U P I N S T U C T I O N S - A L L M O D E L S 1.Remove the TABLE MOUNT from the box\b \b. Bolt to work surface\b It is important to level the table mount so that the post is 90 degrees to the work surface through full range of travel (see VIEW #1) 3. Insert POSTinto mount, and tighten set screws\b 4. Remove remaining body of ErgoArm from box and slide ADJUSTABLE SHOULDER CLAMPover POST\b Tighten screws at desired height (see VIEW...$

$Page 4 4 I N S T A L L A T I O N A N D S E T U P I N S T U C T I O N S - A L L M O D E L S The VERTICAL ADJUSTMENT ROD (Item #41) allows the tool to be adjusted from zero degrees (parallel to column), up to 15 degrees in either direction from zero point\b This compensates for any irregularities in the workpiece or if application requires fastener to be driven in at an angle (see View #3)\b This does not take the place of properly leveling the Table Mount Flange\b Use for ﬁnal 90 degree...$

Start reading Aimco Brakes AcraDyne ErgoArms Operations Manual

Related Manuals for Aimco Brakes AcraDyne ErgoArms Operations Manual

All Aimco Brakes manuals