Aiphone DEUR Instructions User Manual

							83435300 05950 AlPHONE 
TD Series 
DOOR STATION  ADAPTOR 
INSTALLATION & OPERATION MANUAL 
SYSTEM OUTLINE & COMPONENTS 
DE-UR is an adaptor that can add  a door station, audio or  PanTilt video to TD  Phone Selective Call  Intercom. 
IF-DA 
@- 
IF-DA 
5(+,-,D  and two C) to TD-H(or TD-Z)  stations 
A position, preset 
Set 
to B position 
Package  contents 
Packet of screws Installation & Operation  Manual 
*TD-H or TD-Z system is 
powered by a PS-12A  (PS- 
12C),  which  should be  located 
in the middle point  of cable  run. 
Install a DE-UR(s) near  the 
power supply. 
Components available 
* Intercoms TD-H Series: TD-3H/B, TD-6H/B,  TD-I 2H/B & TD-24H/B.  (TD-H/A Series also) 
TD-2 Series: TD-6Z/A & TD-I2Z/A  loop-wired.  Audio door station only. 
0 Intercom 0 Audio door stations 0 Video door  stations 
TD-6HIB  TD-12UA  IF-DA 
Others : IE-FY (not available  in USA)  Others : MY-DG, MY-EA 
It can be 
a combination of MY-CA 
(in MYW-CA enclosure) and  IF-DA. 
NAMES AND FEATURES 
Call tone  selector For TD-H  to have  2 door stations,  DE-UR employs  a 
switch (preset 
to A) to change slow intermittent tone to 
faster  intermittent  tone. 
Features 
* Surface-mount with 83.5mm, 3-5/16 guide. 
* Call tone modulating circuits, 2-1/2-sec. timed. 
* Powered by using systems PS-I 2N12C power supply. * Includes door release control terminals. Front case 
screw 
-1-  
						

							PRECAUTIONS ON INSTALLATION & WIRING 
A CAUTION 
* Do not  connect any terminal on any unit  to AC power lines. 
* Unplug all power supplies while making wiring connections  on any audio and video equipment. 
* DE-UR  is an adaptor for indoor installation only.  Follow precautions as stated  in the Manuals  packed with 
* Locate DE-UR unit(s) closely to power supply  PS-12A (PS-12C)  of TD-H  or TD-Z  system, so as to  be fed  DC12V 
* Wiring to  EL-9S door release must run  in a separate jacketed cable  and apart from intercom wiring. 
TD-H and MY-CU 
monitor. 
from it. 
Before installing DE-UR,  the contents of this Manual  must be thoroughly read  and understood. 
WIRING 
Terminal block layout 
+, -: 
1, 2: 
C: 
D: 
EL,  EL:  12V DC power 
Door station connection 
Selective communication from TD-H/TD-Z  masters 
Call-in tone 
to TD-H  masters (or TD-Z) 
Dry closure contact for door release 
DE-UR & power  supp.:  IocaLJn 
It is suggested to  mount a DE-UR unit(s) in a recessed  area, together with power supply  PS-12A (PS-12C) and 
video adaptor, etc.  Select a location that allows limited access only by qualified personnel,  and is dust-free 
environment possible. 
Audio door station 
k 
EL-SS, AC trans. 
AC 
PanTilt video door station 
/- 4 to TD-H 
AC trans 
AC  AC 
-2- 
2 PanTilt doors plus 1 camera 
6 to MYH-CU 
(r 5 to TD-H 
-UR PS-12Aor 
PS-12c 
camera 
AC  AC 
AC trans  
						

							Wiring 
(door 1) 
1. One audio IE/IF Series 
T 
Rp 
2. Two audio IE/IF Series 
DE-UR  DE-UR 
IF-DA  IF-DA 1 2 DE-UR 
IF-DA 
I 
no no 7 PS-12A 
(PS-12C) 4 wires to 
(max.  12)  to TD-H(TD-2) 
PS-12A 
(PS-12C) 5 wires to to TD-H(TD-2) 
4. Two PanTilt MY Series 3. One PanTilt MY Series (plus one audio) 
MY-CU 
MY-DC 
to  PanTilt 1 
to  PanTilt 2 
TO MY-Ck (camera 
PS-18D 
27 DE-UR  DE-UR 
-0 IF-0 
1- 
(door2) :E I  I 
DE-UR  PS-12A  DE-UR  TD-H 
(max. 12) 
4 I to TD- 
(for MY-DC) (IF-DA) 
-3-  
						

							MOUNTING 
DE-UR 
DE-UR chassis, after separated, mounts with 
83.5mm,  341 6 guide. 
DE-UR DE-UR 
1.  Opening the cover, loosen the bottom screw. 
2.  Lift front case  off the prongs 
of chassis, and 
disconnect  DE-UR. 
3.  Mount the chassis  to wall or board at  2 points. 
4.  Make wire terminations for each door station,  TD-H station, and  PS-l2A(12C) power supply. 
5. Reconnect and mount DE-UR front case to 
chassis. 
Diameter 
Distance 
AWG  Distance 
Pronas 
0.65mm  0.8mm 1 .Omm 
1 Om 15m  20m 
22AWG  20AWG  18AWG 
30  50  65 
3 
-~ _L 
83.5mm  (3-5/16) 
-Chassis 
Distance 
S P E C I F I CAT1 0 N S 
* Power  source: 
* Current consumption: 120mA max. 
* Call tone: 
DC 12V, supplied  by a power supply  PS-12A  (PS-12C) of TD-H (TD-Z)  system. 
Intermittent tremolo, 2-1/2-timed 
150m I 230m I 360m 
* Wiring: 
Distance 
I To audio IE/IF door I 2  conductors laarallel) I 
500 I 750 I 1,200 
1 To TD-H/B stations 1 4 conductors (D, C and + , -) 1 
* Wiring distance: 
From DE-UR to door station 
I Diameter 1 0.65mm I 0.8mm I 1 .Omm 
Ill1 }to TD-H 
* DE-UR  EL, EL terminals capacity: 
* Dimensions: (H x W x D) 160 x  150 x  45 (mm).  6-1/4H x 6W x  1-3/4D 
* 
Weight: 
DC 30V,  1A or  AC 30V, 1A. 
320g (0.71 Ibs.)  approx. 
-4- 4 4 WARRANTY 4 
% 4 
4 
$ 4 
4 
4 
4 
4444444444444444444444444444444444444444444444444444444444444~ 
Aiphone  warrants  its  products to be free  from  defects  of material and  workmanship  under  normal use and  service  for  a  period  of one 
year  after  delivery to the  ultimate  user  and  will  repair  free  of charge  or replace  at  no  charge, should it  become  defective  upon  which 
examination  shall  disclose to be  defective  and  under  warranty.  Aiphone  reserves  unto  itself  the sole  right to make  the  final  decision 
whether there  is a defect  in materials and/or workmanship;  and whether  or not the product  is within  the warranty. 
This  warranty  shall  not  apply 
to any  Aiphone  product  which  has  been  subject to misuse,  neglect,  accident,  or to use  in  violation of 
instructions  furnished,  nor extended  to  units  which  have  been repaired  or altered  outside  of the  factory.  This  warranty does not  cover 
batteries  or damage caused by batteries used in connection with the product. 
This warranty covers bench repairs only, and any repairs must be made at  the shop  or place designated in writing  by Aiphone. 
Aiphone will not be responsible  for any costs incurred involving on site service calls. 
Aiphone Co.,  Ltd., Nagoya, Japan 
Aiphone Corporation, Bellevue, 
WA, USA 
DE-UR-I(E) 0595E 
T 4 4 4  4 
4 
4 
4 
4 
4 4 4 4 
4 
4 4 
4 
4 44 
g KlMU$fiOSKC 
HOME  BUSINESS INDUSTRY Printed in Japan (E) 
-4-