Air Live Router IP-1000R User Manual

							
 59 
6.  The TCP/IP protocol shall be listed in the Network window. Click  OK to complete the install 
procedure and restart your PC to enable the TCP/IP protocol. 
 
A.2 Set TCP/IP Protocol for Working with NAT Router 
1. Click  Start button and choose  Settings, then click  Control Panel . 
2. Double click  Network icon. Select the TCP/IP line that has been associated to your network card in 
the  Configuration  tab of the Network window. 
 
 
3. Click  Properties  button to set the TCP/IP protocol for this NAT Router. 
4.  Now, you have two setting methods:  
						

							
 60
 
a. Select  Obtain an IP address automatically  in the IP Address tab. 
 
b.  Don’t input any value in the Gateway tab. 
 
  
						

							
 61
c. Choose 
Disable DNS  in the DNS Configuration tab. 
 
  B.  Configure IP manually 
a. Select  Specify an IP address  in the IP Address tab. The default IP address of this 
product is 192.168.1.254. So  please use 192.168.1.xxx (xxx  is between 1 and 253) for 
IP Address field and 255.255. 255.0 for Subnet Mask field. 
  
						

							
 62
 
b.  In the Gateway tab, add the IP address of  this product (default IP is 192.168.1.254) in 
the New gateway field and click  Add button. 
 
 
c.  In the DNS Configuration  tab, add the DNS values which  are provided by the ISP into 
DNS Server Search Order field and click  Add button. 
                                    
						

							
 63
A
A
A p
p
p p
p
p e
e
e n
n
n d
d
d i
i
i x
x
x  
 
  B
B
B  
 
   
 
  F
F
F A
A
A Q
Q
Q  
 
  a
a
a n
n
n d
d
d  
 
  T
T
T r
r
r o
o
o u
u
u b
b
b l
l
l e
e
e s
s
s h
h
h o
o
o o
o
o t
t
t i
i
i n
nn
g
g
g  
 
 
 
Reset to factory Default
 
 
There are 2 methods to reset to default. 
 
1. 
Restore with RESET button 
First, turn off the router and press the RESET button in . And then, power on the router and push the RESET button 
down until the M1 and or M2 LED (or Status LED) start flashing, then remove the finger. If LED flashes about 8 
times, the RESTORE process is completed.  However, if LED flashes 2 times, repeat. 
 
2.  Restore directly when the router power on  
First, push the RESET button about  5 seconds (M1 will start flashing about 5 times), remove the finger 
. The RESTORE process is completed.