Home > AL-KO > Caravan & Motorhome > AL-KO AKS 1300 Stabiliser Instructions User Manual

AL-KO AKS 1300 Stabiliser Instructions User Manual

Add to Favourites
    Download as PDF

    View the AL-KO AKS 1300 Stabiliser Instructions User Manual for free. All the AL-KO manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 OPERATING INSTRUCTIONS FOR AL-KO AKS 1300 STABILISER INTRODUCTION 1 The AKS 1300 must be used in conjunction with 50 mm dia. towballs which conform to EC Directive 94/20 (DIN 74058 or local equivalent). 2 Suitable for attachment to drawbars or approved overrun braking equipment for single axle (and some tandem axle) caravan/trailers, with a minimum weight of 180 Kg and a maximum permissible weight of 1360 Kg. 3 EC design approval has been given to the AL-KO AKS 1300 coupling under permit No....
    Page 2 OPERATING INSTRUCTIONS FOR AL-KO AKS 1300 STABILISER RESTRICTIONS OF USE Spare wheels fitted to rear door of vehicle, or vehicle with platforms etc: 1 The AKS 1300 Stabiliser is based on the latest regulations. This means the new DIN 74070 (dimensions of couplings) are also adhered to. 2 The trailer coupling may only be connected to towing vehicles where the clearance for the stabiliser can be observed, in accordance with Directive 94/20 EC (DIN 74058). If these clearances are infringed by...
    Page 3 OPERATING INSTRUCTIONS FOR AL-KO AKS 1300 STABILISER REMOVAL OF EXISTING FIXING BOLTS Before you start to remove the existing fixing bolts, please note that on most over-run assemblies, the shock absorber is secured by the fixing bolt (Fig 4/Item 2). WARNING The shock absorber (damper) extends independently. Enclosed with this box is a retaining pin (Fig 5) to aid assembly. a Remove gaiter b Loosen self-locking nut from hexagon cap bolt (Fig 4/1 Fig 4/2) c Push or knock out hex. cap bolt (Fig 4/Item...
    Page 4 OPERATING INSTRUCTIONS FOR AL-KO AKS 1300 STABILISER STABILISER LEVER CLEARANCES (FIG 7) No component parts are allowed in the space marked X. The measurement of X should correspond at least to the travel of the overrun equipment (as a rule 80 - 100 mm according to type). Measurement is taken with a fully extended drawbar. AL-KO overrun equipment fulfils this requirement. Coupling to Trailer Measurements (attachment hole dimensions B horizontal or cross) Please check dimensions of your coupling...
    Start reading AL-KO AKS 1300 Stabiliser Instructions User Manual

    Related Manuals for AL-KO AKS 1300 Stabiliser Instructions User Manual

    All AL-KO manuals