Aleratec DVD CD RoboRacer LS Fully Automatic LightScribe Publisher User Guide

							www.aleratec.com7
7. If you did not de-check the box and the 280110 was not plugged into 
the USB port or the power to the device was turned off then the display 
box will show:  
						

							www.aleratec.com8
\bero Essentials Insta\ollation
1. Open the Nero installation utility.  Click “Install Nero 7 Essentials”. 
2. Click “Nero 7 Essentials” again.  
						

							www.aleratec.com9
3. After a short delay, Windows Installer will start the Nero installation Wizard.  
When this screen is shown, click “Next”.
4. Agree to the user agreement by checking the checkbox in the lower left 
corner.  Then click “Next”.  
						

							www.aleratec.com10
\bero Essentials Insta\ollation - continued
5. At this screen, fill out the fields you would like.  When finished clicked 
“Next”. Leave the Serial Number that is automatically displayed.
6. Choose the “Custom” option and click “Next”.  
						

							www.aleratec.com11
7. Select the languages you want to be supported and click “Next” on this 
screen.
8. Select only “Nero Express Essentials” and “Nero CoverDesigner”, then 
click “Next”.  
						

							www.aleratec.com12
\bero Essentials Insta\ollation - continued
9. When the final setup is complete, click “Install” to begin the installation 
process.
10. During the installation process this screen will be displayed.  
						

							www.aleratec.com13
11. Near the end of the installation process, this screen will appear asking 
if you would like to install any shortcuts.  Check the boxes of the 
shortcuts you would like and then click “Next”.
12. When installation is complete this screen will appear.  Click “Finish” to 
exit back to the installer display.  
						

							www.aleratec.com14
\bero Essentials Insta\ollation - continued
13. Once back to this screen, click “Exit”. 
14. You can now exit this screen as well by clicking “Exit”.  You are ready 
to use the RoboRacer LS.  
						

							www.aleratec.com15
Updating the LightS\ocri\fe System Softwa\ore
1. To install the LightScribe Utility needed to use the LightScribe feature 
of the 280110 click on the LS installer.
2. Choose the “Run” option on the Windows security warning to allow the 
installer to begin.
3. The installer will begin by extracting the installer.  
						

							www.aleratec.com16
Updating the LightS\ocri\fe System Softwa\ore - continued
4. When extraction is complete The InstallShield Wizard will begin.  
Click the “Next” button.
5. Agree to the License Agreement by choosing the upper bubble and 
click the “Next” button.