AllTrade Kawasaki 10in Compound Miter Saw 840378 User Manual

3. Tighten the locknut on the bevel
adjustment screw.
TO ALIGN THE BEVEL INDICATOR:
1. Loosen the locknut and adjust the
bevel indicator up or down until it
aligns with the 0° mark.
2. Tighten the locknut.
ADJUSTING THE BEVEL
When the handle assembly is against 
the bevel hex nut, the bevel 
indicator should be at the 45° mark.
TO ADJUST THE BEVEL:
1. Loosen the bevel stop hex nut.
2. Use a 10mm wrench to turn the bevel
stop screw up or down until the bevel
indicator reaches the 45° mark.
3. Retighten...

If a saw blade shows signs of wear or damage, replace it immediately. Dull or 
damaged saw blades are not safe and may cause personal injury.
ALWAYSmake sure the saw is unplugged and the blade stopped before changing
blades.
NEVERuse a blade larger than 
10 in diameter.
TO CHANGE THE BLADE:
1. Make sure the saw is in the up position.
2. Remove the three mounting screws (as
indicated by arrows)  and remove the
lower guard. 
3. Push in on the arbor lock to keep the
blade from spinning and use the 
socket...

CUTTING CROWN MOULDING, TRIMS AND BASEBOARDS
Cutting crown moulding, trims and baseboards must be done very accurately. If the
angles are not correct, the mouldings will not fit flush with the wall, the ceiling or
each other.
Always practice on scrap material before attempting to
cut the final workpiece.
BASEBOARDS
1. To prevent damaging the surface of the moulding, tape all contact areas before
clamping.
2. Make sure workpiece lies flat against the miter table with one edge pressed 
firmly against the...

Make sure the lower blade guard is operating properly before each use. If the lower
blade guard is damaged or missing, do not use your saw.
Never use solvent or harsh detergents to clean the lower
blade guard. Solvent will damage the plastic. Clean with a damp cloth only.
TO CLEAN LASER UNIT:
1. Make sure the laser and saw switches are turned OFF and unplug the saw.
2. Pull off laser cover.
3. Remove the two screws and washers holding the laser unit to the saw.
4. Lift out laser unit.
5. Dust the laser...

any such nonconforming item and/or part is promptly returned to Alltrade’s facility
postage pre-paid and insured (address: ALLTRADE Warranty Claims & Repair, 
1431 Via Plata, Long Beach, CA 90810, Attn: Customer Service #1-800-590-3723)
within the applicable warranty period, with a written request by purchaser that
Alltrade repair and/or replace the nonconforming item and/or part. We recommend
that you keep the original product packaging in the event you need to ship the unit.
We suggest the package be...

PURCHASER KNOWINGLY AND WILLINGLY WAIVES ANY AND ALL SUCH 
WARRANTIES AND RIGHTS, CLAIMS AND/OR CAUSES OF ACTION ARISING
THEREFROM OR BASED THEREON. PURCHASER’S SOLE AND EXCLUSIVE 
REMEDY IS AS STATED ABOVE.
L Li
im
mi
it
ta
at
ti
io
on
n 
 O
Of
f 
 L
Li
ia
ab
bi
il
li
it
ty
y
IN NO EVENT SHALL ALLTRADE AND/OR ITS REPRESENTATIVE(S) BE LIABLE FOR
INDIRECT, INCIDENTAL, SPECIAL AND/OR CONSEQUENTIAL DAMAGES OF ANY
KIND ARISING OUT OF OR RELATED TO, DIRECTLY OR INDIRECTLY, ANY BREACH
OF ANY PROVISION OF ANY...