Apple power mac g4 fw 800 User Manual
Here you can view all the pages of manual Apple power mac g4 fw 800 User Manual. The Apple manuals for Personal Computer are available online for free. You can easily download all the documents as PDF.
Page 51
Power Mac G4 (Mirror/FW 800) Take Apart - 49 Speaker Tools The following tools are required for this procedure: • #2 Phillips screwdriver. • Small flat-blade screwdriver Part Location Preliminary Steps Before you begin, do the following: • Open the side access panel. • Remove the optical drive carrier.
Page 52
50 - Power Mac G4 (Mirror/FW 800) Take Apart Speaker Procedure 1. Using a small flat-blade screwdriver, lift up the locking tab on the speaker cable connector and disconnect the cable from the logic board. 2. Remove the cable from the cable guide. 3. Route the cable up and out through the opening in the optical drive shelf and out from under the speaker case.
Page 53
Power Mac G4 (Mirror/FW 800) Take Apart - 51 Speaker4. Remove the speaker mounting screw. 5. Swing the speaker away from the chassis. Press in on the two latches on the right side of the speaker and release the speaker from the chassis.
Page 54
52 - Power Mac G4 (Mirror/FW 800) Take Apart Speaker 6. Remove the speaker and cable from the computer. Replacement Note: With the replacement speaker attached to the chassis, make sure to route the speaker cable through the chassis guides, as shown.
Page 55
Power Mac G4 (Mirror/FW 800) Take Apart - 53 Optical Drive Bezel Optical Drive Bezel Tools No tools are required for this procedure. Part Location Preliminary Steps Before you begin, do the following: • Open the side access panel. • Remove the optical drive carrier.
Page 56
54 - Power Mac G4 (Mirror/FW 800) Take Apart Optical Drive Bezel Procedure 1. Press in and release the top two latches on the inside of the optical drive bezel. 2. Press in and release the bottom two latches. 3. Remove the bezel from the computer.
Page 57
Power Mac G4 (Mirror/FW 800) Take Apart - 55 Front Panel Board Front Panel Board Tools The following tools are required for this procedure: • #2 Phillips screwdriver • Small flat-blade screwdriver • Needlenose pliers Part Location Preliminary Steps Before you begin, do the following: • Open the side access panel. • Remove the optical drive carrier. • Remove the optical drive bezel.
Page 58
56 - Power Mac G4 (Mirror/FW 800) Take Apart Front Panel Board Procedure 1. Disconnect the front panel board cable from the front panel board. 2. Using a small flat-blade screwdriver, pry up the two black plastic pegs and then the two black plastic peg holders from the top of the front panel board. 3. Using a #2 Phillips screwdriver, remove the front panel board mounting screw. 4. Remove the front panel board through the front opening in the computer.
Page 59
Power Mac G4 (Mirror/FW 800) Take Apart - 57 Front Panel BoardReplacement Note: When replacing the black plastic peg holders, use needlenose pliers to compress the holders so they will fit into the holes in the top of the front panel board.
Page 60
58 - Power Mac G4 (Mirror/FW 800) Take Apart Front Panel Board Cable Tools No tools are required for this procedure. Part Location Preliminary Steps Before you begin, do the following: • Open the side access panel. • Remove the front hard drive carrier. • Remove the optical drive carrier. • Loosen the speaker cable.