Apple power mac g4 quicksilver User Manual
Here you can view all the pages of manual Apple power mac g4 quicksilver User Manual. The Apple manuals for Personal Computer are available online for free. You can easily download all the documents as PDF.
Page 131
Take ApartFan, PCI Graphics, AGP Graphics/Gigabit Ethernet/Digital Audio - 109 Fan, PCI Graphics, AGP Graphics/Gigabit Ethernet/Digital Audio Before you begin, open the side access panel.
Page 132
Take ApartFan, PCI Graphics, AGP Graphics/Gigabit Ethernet/Digital Audio - 110 1. Remove the two screws on the fan bracket. 2. Pull the fan bracket down to access the power-to-fan connector. 3. Disconnect the power- to-fan connector.
Page 133
Take ApartFan, PCI Graphics, AGP Graphics/Gigabit Ethernet/Digital Audio - 111 4. Lift the fan bracket out of the computer. Replacement Note: The fan bracket has two holes (on the top) that join with two tabs on the chassis. If the tabs arenÕt inserted into the holes, the screws that secure the fan bracket to the chassis wonÕt align properly.
Page 134
Take ApartFan, PCI Graphics, AGP Graphics/Gigabit Ethernet/Digital Audio - 112 Perform the following procedure only if you are replacing the fan. 5. Using a Phillips screwdriver, remove the four screws securing the fan to the fan bracket. 6. Lift the fan from the fan bracket.
Page 135
Take ApartPower Supply, Power Mac G4 (QuickSilvers) - 113 Power Supply, Power Mac G4 (QuickSilvers) Before you begin, do the following: ¥ Open the side access panel. ¥ Remove the CD/DVD/Zip drive carrier.
Page 136
Take ApartPower Supply, Power Mac G4 (QuickSilvers) - 114 1. Press the small locking tab on the power-to-fan cable connector and disconnect the cable.
Page 137
Take ApartPower Supply, Power Mac G4 (QuickSilvers) - 115 2. Disconnect the main power cable from the logic board and the power cables to any hard drives.
Page 138
Take ApartPower Supply, Power Mac G4 (QuickSilvers) - 116 3. Using a 2.5 mm Allen wrench, remove the three screws on the rear vented panel.
Page 139
Take ApartPower Supply, Power Mac G4 (QuickSilvers) - 117 4. Remove the four screws that attach the power supply and main power supply cable to the chassis.
Page 140
Take ApartPower Supply, Power Mac G4 (QuickSilvers) - 118 5. Slide the power supply toward the front of the computer until it clears the security bar on the upper inside corner of the chassis.