Home > Armscor > Firearms > Armscor M1600r Instructions Manual

Armscor M1600r Instructions Manual

Add to Favourites
    Download as PDF

    View the Armscor M1600r Instructions Manual for free. All the Armscor manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 ARMSCOR M16 R / M1600 R USER’S MANUAL WARNING: READ THE INSTRUCTIONS AND SAFETY PRECAUTIONS IN THIS MANUAL CAREFULLY BEFORE USING THIS FIREARM. DISCHARGING FIREARMS IN POOLY VENTILATED AREAS, CLEANING FIREARMS OR HANDLING AMMUNITION MAY RESULT IN EXPOSURE TO LEAD AND OTHER SUSBSTANCES KNOWN TO THE STATE OF CALIFORNIA TO CAUSE BIRTH DEFECT, REPRODUCTIVE HARM AND OTHER SERIOUS PHYSICAL INJURY. HAVE ADEQUATE VENTILATED AT ALL TIMES. WASH YOUR HANDS THOROUGHLY AFTER EXPOSURE....
    Page 2 TO MAKE GUN SAFE: Safety lever is at the right side of the receiver and at the back of the bolt operating handle. Pull safety latch toward the “S” mark on the receiver. This locks trigger and gun cannot be fired. TO LOAD CHAMBER: With the safety on, insert a loaded magazine into the rifle. Pull the bolt operating handle all the way to the rear and release, allowing the bolt to move forward under full force of the operating springs. Bolt automatically picks up a cartridge from the magazine...
    Page 3 1. Loosen receiver cap lock screw and unscrew receiver cap. Be careful, as spring inside are under pressure. 2. Pull out the unit assembly (recoil spring, recoil spring retainer and guide sleeve, firing pin spring, firing spring pin spring guide head and stem). Keep in order together with the receiver cap to avoid confusion in re-assembly. 3. With muzzle pointing upwards, fully retract bolt handle fully to the rear end of the receiver slot. 4. Push firing pin forward so as to align its tail end...
    Page 4 8. Insert the entire unit inside the receiver, shorter sleeve resting against the bolt together with the receiver cap and compress the springs carefully to return the receiver cap into its original position. Tighten the receiver cap lock \ screw. 9. Pull bolt handle back and forth several times to check the action of the bolt and trigger assembly. B.TRIGGER ASSEMBLY 1. With gun in an upside down position, insert trigger spring follower into \ the trigger spring and mount it into the spring hole....
    Start reading Armscor M1600r Instructions Manual
    All Armscor manuals