Asus Router RT-N15 User Manual

							
RT-N15 Wireless Router User Manual
2

2) Setting up the network sharing center
Follow the steps below to set up a sharing center to allow the network u\
sers to 
share printer, file and media.
1. Connect the device to your PC and power it on.
2.  Click 
Network and Sharing Center in the navigation bar. The Network and Sharing Center screen appears. 
						

							
RT-N15 Wireless Router User Manual
30

3. Click Set up a wireless router or network.
4. Choose Set up a wireless router or access point, then click Next. 
						

							
RT-N15 Wireless Router User Manual
31

5. Click Next.
6. In the screen that appears, type a network name in the Network name box, then click Next. A passphrase is generated for the WPA security. 
						

							
RT-N15 Wireless Router User Manual
32

7. Click Next. If you want to use security methods other than WPA-Personal, click Show advanced network security options. 
8.  Choose a security method and click Next. 
						

							
RT-N15 Wireless Router User Manual
33

9.  A screen prompts you to enter the PIN for the device. Enter the PIN, whic\
h is located on the sticker posted on the device, then click Next. 
10.   Choose a file and printer sharing option and click Next. 
						

							
RT-N15 Wireless Router User Manual
34

 A screen appears showing that the set up is complete as shown below.
11.   From the above screen you can choose to View settings or, Save settings to a USB flash drive. The respective screens are shown below.
View settings screen 
						

							
RT-N15 Wireless Router User Manual
35

Save settings to a USB flash drive screen
12. When Save settings to a USB flash drive screen appears, plug a USB flash drive into your computer, then select the drive from the Save settings to box and click Next. The settings starts to be saved into the USB drive. 
  After the saving process is completed, a screen appears to instruct you \
to add computer 
or other devices into the network. Follow the instructions to add comput\
ers and devices into your network. 
						

							
RT-N15 Wireless Router User Manual
36

7. Troubleshooting
Cannot access to web browser for router configuration
1. Open a web browser and open "Internet Options" dialog box.
2. Click on "Delete Cookies" and "Delete Files".
Cannot Establish Connection via Wireless
 Out of Range:
 •  Put the router closer to the wireless client.
  •  Try to change the channel setting.
  Authentication:
 •  Use wired connection to connect to router. 
  •  Check the wireless security setting.
•   Do the hard reset on the wireless router by pressing the Reset button on the rear\
 panel
 for more than 5 seconds.
  Couldn't find the router:
• Do the hard reset on the wireless router by pressing the Reset button on the rear panel for more than 5 seconds.
  • Check the setting in the wireless adapter such as SSID and encrypti\
on setting.
Cannot get access to the Internet via wireless LAN adapter
 • Move the router closer to the wireless client.
• Check whether the wireless adapter is connected to the correct AP.
 • Check whether the wireless channel in use conforms to the channels \
available in your 
country/ area.
  • Check encryption setting.
  • Check whether the ADSL or Cable connection is correct.
  • Retry using another Ethernet cable. 
						

							
RT-N15 Wireless Router User Manual
37

Internet is not accessible
• Check the lights on ADSL modem and the Wireless Router.
•   Check whether the "WAN" LED on the Wireless Router is ON. If the LED is not ON, 
change the cable and try again.
When ADSL Modem "Link" light is ON (not blinking), this means Internet 
Access is Possible.
• Restart your computer.
• Refer to the Quick Setup Guide of the wireless router and reconfigu\
re the settings.
• Check whether the WAN LED on the router is ON or not.  
• Check wireless encryption settings.
• Check whether the computer can get the IP address or not (via both wired network and wireless network).
• Make sure your Web browser is configured to use the local LAN, and is not configured to use a proxy server.
If the ADSL "LINK" light blinks continuously or stays off, Internet access is 
not possible - the Router is unable to establish a connection with the ADSL 
network. 
• Make sure your cables are all correctly connected .
• Disconnect the power cord from the ADSL or Cable modem, wait a few minutes, then reconnect the cord.
• If the ADSL light continues to blink or stays OFF, contact your ADSL service provider.
Network name or encryption keys are forgotten
•  Try to setup the wired connection for setup the wireless encryption again\
.
•   Do the hard reset on the wireless router by pressing the Reset button on the rear panel for 
more than 5 seconds.
How to reset to defaults
The following are factory default values. If you push the Restore button on the back of the ASUS Wireless Router for over 5 seconds, or click the “Restore” button on the “Factory Default”  page under “ Advanced Setup”, the following default settings overwrite the old settings on your wireless router.
  User Name:     admin        Subnet Mask:  255.255.255.0
  Password:     admin        DNS Server 1:  192.168.1.1
  Enable DHCP:   Yes (if plug in Wan cable)  DNS Server 2:  (Blank)
  IP address:     192.168.1.1      SSID:     default
  Domain Name:   (Blank) 
						

							
RT-N15 Wireless Router User Manual
38

8. Appendix
FCC Warning Statement
This device complies with Part 15 of the FCC Rules. Operation is subject\
 to the following two conditions: 
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including inter\
ference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: 
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Prohibition of Co-location
This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.
Safety Information
To maintain compliance with FCC’s RF exposure guidelines, this equipme\
nt should be installed and operated with minimum distance 20cm between the radiator a\
nd your body. Use on the supplied antenna.
Declaration of Conformity for R&TTE directive 1/5/EC
Essential requirements – Article 3
Protection requirements for health and safety – Article 3.1a