Bang & Olufsen BV11 User Manual

							Installation and setting up 
22 Set up your television 
23
 C
leaning 
24
 C

onnection panels 
Contents – Installation and setting up 21  
						

							Set up your television 
Important 
To ensure proper ventilation, allow enough space around the screen. At over h eating (flashing standby 
indicator and an on-screen warning), switch the T V to standby, not off, in order for the T V to cool  down. You cannot operate the T V during this time. 
If the front screen glass should crack or chip, or if it should be damaged in any way, it must be replaced 
immediately, as it could otherwise cause injury. You can order replacement front screen glass from your 
Bang & Olufsen retailer. 
Ventilation
Front glass 
We recommend that you place the T V in the 
packaging while you fasten the wall bracket or the 
bracket for the stand to the back of the T V.
Set the maximum angle the T V will turn on the  motorised stand or wall bracket. The wall bracket 
without a motor can manually be turned 90˚ left or  right depending on your setup. Remember to leave 
enough space around the T V to allow it to turn 
fre ely. 
The T V has several placement options. Refer to 
www.bang-olufsen.com  for available stands and 
wall brackets or contact your Bang & Olufsen  retailer.  Due to the weight of the T V, any moving or lifting 
of the T V should be performed by qualified personnel – using the proper equipment.
Handling 
Wall bracket and stand  Placement options 
The television has several placement options. Follow the guidelines for placement 
and connection. 
22  
						

							Installation and setting up 
Maintenance Screen 
Cabinet and controls  Never alcohol  Regular maintenance, such as cleaning, is the responsibility of the user. 
Use a mild window cleaning fluid and lightly clean the screen without leaving streaks or traces. Some micro-fibre cloths  may harm the optical coating due to their strong abrasive effect. 
Wipe dust off the surfaces using a dry, soft cloth. To remove stains or dirt, use a soft, damp cloth and a solution of water  and mild detergent, such as washing-up liquid. Never use alcohol or other solvents to clean any parts of the T V. 
Cleaning 
Gather the cables from each side, make the  bundles cross each other, and fasten them to 
either side or in the middle, depending on wall  bracket or stand placement.  If you have a motorised stand or wall bracket, 
make sure that there is enough slack in the 
cables to allow the T V to turn to either side  before you fasten the cables with cable ties to 
make a neat bundle. 
Locate the connection panel and other important 
items: 
When the T V is placed on a wall bracket or stand  you can attach the speaker cover. 
Hold the speaker cover with both hands and place 
the pins into the holes at the bottom first. Then  carefully place the pins into the holes at the top 
and push down. During cleaning it is recommended to remove the 
speaker cover. Avoid spraying liquid directly on 
the screen as this may damage the speakers, use a  soft cloth instead. 
Carefully remove the speaker cover by supporting  it in the side and at the bottom. 
1
 
M
 ounting bracket for wall bracket. 
2  
M
 ounting bracket for stand. 
3  
C
 overs for the main connection panel. Pull out 
at the bottom to remove the cover parts. 
4  
S
 ocket for temporary connections. Press in the 
middle to open. 
Depending on your setup, lead the cables through 
the hole in the middle or either sides of the  connection panel cover.
Run cables
Overview 
Fasten the speaker cover
33 3
433
23  
						

							Connection panels 
Any equipment you connect to the main connection panel must be registered in the SOURCE LIST SETUP menu. Equipment connected to the top connection panel  can be registered in the SOURCE LIST SETUP menu. 
Information 
Connect the ~ socket on the main connection panel of your T V to the wall outlet. The T V is in standby mode and ready to be used. 
The supplied plug and mains cord are specially designed for the product. Do  not change the plug, and if the mains cord is damaged, you must buy a new 
one from your Bang & Olufsen retailer.  ~ – Mains supply 
Connection to the mains supply. 
PL 1–5 (Power link) For connection of external speakers in a surround 
sound setup. See the online guide for more  information. 
MONITOR CONTROL  For future use. 
PUC 1–3 A+B  For IR control signals to external equipment 
connected to an HDMI IN or AV IN socket. Allows 
you to control non-Bang & Olufsen equipment  with your Bang & Olufsen remote control.  
C TRL (1–2)  For future use.  EX T. IR 
For future use. 
HDMI IN (1–5) 
The High Definition Multimedia Interface allows  you to connect many different video sources, such 
as set-top boxes, multimedia players, Blu-ray  players, or a PC. 
AV IN  For connection of analogue video equipment. 
S/P-DIF IN  Digital audio input socket, for example, a PC. 
USB  (
) 
For connection of a USB device to browse digital  photos, video or music files. 
 Ethernet*1
For connection to the Internet. For software 
updates, access to WebMedia and PUC  downloads. 
1*Make sure the cable connection between the 
product and the router does not exit the building 
to avoid contact with high voltage.
Mains cord and plug 
PL 5
PL 4MONITOR
CONTROL PUC 2
A+B PUC 1
A+BEXT. IR
PL 3 PL 2 PL1
PUC 3 A+B
CTRL 3 CTRL 2CTRL 1 1
2
3
4
5S/P-DIF
IN 
STANDAV IN
CHIPSIDE
CHIPSIDE
AERIALSATELLITECOMMON INTERFACE 21
24  
						

							Installation and setting up 
Temporary connectionsEthernet connection Online guide  You can connect headphones and listen to a programme, or you can connect a camera and watch your 
home movies on the T V. 
Connect your television to the Internet to receive software updates and download Peripheral Unit 
Controller (PUC) tables. It is recommended that you set your television to update software automatically.
The online guide includes more information about setup and connection of external equipment.
S TA N D
 
For connection of a motorised stand or wall  bracket. See the online guide for calibration of 
stand or wall bracket. 
AERIAL  Aerial input socket for an external aerial/cable T V  network or for an analogue signal. 
SATELLITE (1–2) 
Aerial input sockets for a digital satellite signal.  Depending on your tuner options, you may have either one, two, or no satellite sockets. 
2 x PCMCIA (CA Module)  For insertion of a module and card for access to 
coded digital channels. For more information 
about compatible card and module combinations,  contact your Bang & Olufsen retailer. 
Sockets for temporary connections 
HDMI IN (6)HDMI IN connection of additional video equip-m

ent. You can also connect a camera or a game 
console.
PHONES  (
)
For connection of stereo headphones. 
>
 
T

o mute speakers, press in the middle of the 
  button. (Beo6: Turn the volume wheel 
quickly counter-clockwise). 
>
 
 P

ress 
 or  to adjust volume in headphones. 
(Beo6: Turn the volume wheel either way). 
>
 
T

o restore sound in speakers, press the middle 
of the 
  button. (Beo6: Turn the volume 
wheel quickly counter-clockwise). 
NOTE! Prolonged listening at high volume levels  can cause hearing damage! 
USB  (
) 
For the connection of a USB device, such as a  media browser (HomeMedia), to browse digital photos, video or music files. 
We recommend that you connect the television to the Internet to be able to 
receive software updates and to download Peripheral Unit Controller (PUC) tables. 
PUC tables enable you to operate connected non-Bang & Olufsen products with 
your Bang & Olufsen remote control. 
6
25
Push to open the cover to access the HDMI IN,   headphones and USB sockets. Push again to close 
it.  
						

							Hereby, Bang & Olufsen declares that this 
television with WL AN is in compliance with the  essential requirements and other relevant provisions of Directive 1999/5/EC. The Declaration 
of Conformity may be consulted at www.bang- olufsen.com/guides . 
See www.bang-olufsen.com/guides  for more 
information. 
AT, BE, BG, CH, CY, CZ, DE, DK, EE, ES, FI, FR, GB,  GR, HU, IE, IS, IT, LI, LT, LU, LV, MT, NL, NO, PL, PT, RO, SE, SI, SK, TR. 
This equipment should be installed and operated  with minimum distance 20 cm between the 
antenna and your body.
This product incorporates copyright protection  technology that is protected by U.S. patents and other intellectual property rights. Use of this 
copyright protection technology must be 
authorized by Rovi Corporation, and is intended 
for home and other limited viewing uses only  unless otherwise authorized by Rovi Corporation. 
Reverse engineering or disassembly is prohibited.
HDMI, the HDMI Logo and High-Definition  Multimedia Interface are trademarks or registered 
trademarks of HDMI Licensing LLC.  Electrical and electronic equipment, parts and 
batteries marked with this symbol must not be disposed of with normal household wastage; all 
electrical and electronic equipment, parts and  batteries must be collected and disposed of 
s eparately. 
When disposing of electrical and electronic  equipment and batteries by use of the collection 
systems available in your country, you protect the  environment, human health and contribute to the prudent and rational use of natural resources.  Collecting electrical and electronic equipment, 
batteries and waste prevents the potential 
contamination of nature with the hazardous 
substances which may be present in electrical and  electronic products and equipment. 
Your Bang & Olufsen retailer will advise you of the  correct way of disposal in your country. 
Waste Electrical and Electronic Equipment 
(WEEE) – Environmental protection 
This product complies with applicable environmental legislation throughout the world. 
Beo40889
Manufactured under license from  Dolby Laboratories. Dolby and the double-D symbol are trademarks 
of Dolby Laboratories.
Manufactured under license  under U.S. Patent Nos: 5,956,674; 
5,974,380; 6,487,535 & other U.S.  and worldwide patents issued & pending. DTS, the Symbol, & DTS 
and the Symbol together are  registered trademarks & DTS 
Digital Surround and the DTS  logos are trademarks of DTS, Inc. 
Product includes software. © DTS,  Inc. All Rights Reserved.
1 
2 
3 
1 
2 
26  
						

							27