Beko Dfn 6833 B Manual

28
Adjusting the height of empty 
upper basket
(depends on the model)
You can adjust the height of the upper 
basket according to the size of the dish 
to be washed. Use basket rollers to 
change the basket height. 
1. Turn the stoppers on the ends of 
the upper basket rails by turning 
them aside (A). 
2. Take the basket out (B). 
3. Change the position of the rollers, 
place the basket into the rail and 
close the stoppers (C).
1022 eps
\037
\036
\035 
EN  

29
5Operating the product
1. On/Off key
2. Start / Pause / Cancel key
3. Display
4. Programme Selection key
5. Half Load key
6. Express key 
7. Tablet Detergent key
8. Time Delay key
9. Handle
10. Programme indicator
11 .  Remaining Time / Delay Time 
indicator
12. Start / Pause indicator
13. Time Delay indicator
14. Rinse Aid  indicator
15. Half Load “” indicator
16. Express indicator 
17. Tablet Detergent indicator
18. Salt indicator
19. Child Lock indicator
20. Programme Steps Follow-up 
indicators
 a...

30
Keys
On / Off key
It is used to turn on or off the machine. 
In On position, the machine switches 
on with the last programme in use. In 
Of position, indicators on the display 
will turn off.
If the Half Load, Tablet Detergent, 
Child Lock and Time Delay functions 
were selected in the previous 
programme used, these functions will 
remain active when the machine is 
turned off and on again. If you want to 
disable these functions after turning the 
machine off and on again, you must 
press the...

31
Programme selection
1. Press On / Off key to turn on your 
machine.
2. Refer to “Table of Programme Data 
and Average Consumption Values” 
to select a washing programme 
suitable for your dishes.
3. Press Programme Selection key 
 repeatedly until the number of 
the selected programme appears 
on the Programme indicator 
. Programme number 
will increase by one each time you 
press the key. 
C Number of the programmes on the 
machine may change depending 
on the model you have purchased.
Adding an...

32
YM_program_
takibi
the estimated time to the end of the 
programme. Start / Pause indicator 
starts lighting continuously.
C Your machine performs water 
softening depending on the hardness 
level of the supply water. Remaining 
time displayed towards the end in 
some programmes can be different 
from the time indicated at the 
beginning due to this process. The 
total time can also change while the 
programme is running depending on 
the ambient temperature where your 
machine is installed,...

33
C You can select and operate a 
new programme following the 
cancellation of the programme.
C There might be residues of 
detergent or rinse aid left in the 
machine and/or on the pieces 
being washed depending on the 
step the previous programme was 
in at the time of such cancellation.
Salt indicator
Check the Salt indicator on the display 
to see whether there is enough 
softening salt in your machine or not. 
You need to refill the salt container 
whenever the Salt indicator lights.
C If the water...

34
Programme Table
Programme number
1
2
3 Reference*
4
5
6
7
8
Programme name
Cleaning temperature
Degree of Soiling
 Suitable for removing the remnants on the soiled dishes that will be kept waiting in the machine for a few days, and thus, for preventing the bad odor buildup.
Suitable for lightly soiled daily dishes that are scraped or pre-cleaned.  
Most economical washing program for the medium soiled daily dishes that are kept waiting.  
Daily washing program at which the medium soiled dishes that...

35
1. Turn the micro filter (3) and 
coarse filter (2) assembly counter 
clockwise and pull it out from its 
seating (A).
6Maintenance and cleaning
Service life of the product extends and 
frequently faced problems decrease if it 
is cleaned at regular intervals. 
A Unplug the product and turn off the 
tap before attempting any cleaning 
procedures.
C  Do not use abrasive substances for 
cleaning.
C Clean the filters and impellers at 
least once a week.
Cleaning the outer surface of 
the product
Clean...

36
\037
\036
\035
\034
\033
\032
4.  Clean all three filters under tap 
water by means of a brush.
5. Replace the metal/plastic filter.
6. Place the coarse filter into the 
microfilter. Make sure that it is 
properly seated. Turn the coarse 
filter clockwise until a “click” sound 
is heard. 
A Do not use the dishwasher without 
filter.
C  Incorrect placement of the filters 
will reduce washing efficiency.
Cleaning the hose filter
Damages on the machine that may be 
caused by impurities coming from the...

37
1032
Upper impeller
Check if the holes on the upper 
impeller (2) are clogged. If they 
are clogged, remove and clean the 
impeller. Turn its nut to left to remove 
the upper impeller (C, D).
Make sure that the nut is tightened well 
when installing the upper impeller. 
\037
\036
\035
\034
\033
\032 
EN