Beko Wmb 61221 W Manual

21EN
laundry with the set spin speed and drain the water coming out of them.
If you wish to drain only the water without spinning your laundry, select the Pump+Spin programme and then select the No Spin function with the help of Spin Speed Adjustment button. Press Start / Pause button.
C Use a lower spin speed for delicate laundries.
Temperature selection
Whenever a new programme is selected, the recommended temperature for the selected programme appears on the temperature indicator.
To decrease the...

22EN
Programme and consumption table
EN2Auxiliary functions
Programme
Max. Load (kg)Programme Duration (~min)Water Consumption (l)Energy Consumption (kWh)Max. Speed***PrewashQuicker Wash /Quick WashExtra RinseAnti- CreaseRinse HoldPet hair removal
Selectable temperature range °C
Cottons906150652.001600••••••Cold-90
Cottons606122651.351600••••••Cold-90
Cottons406102650.701600••••••Cold-90
Cottons Eco60**6160441.011600•40-60
Cottons Eco60**3130370.821600•40-60
Cottons Eco40**3130370.641600•40-60
Time...

23EN
• Selectable
* Automatically selected, no cancelling.
** Energy Label programme (EN 60456 Ed.3)
*** If maximum spin speed of the machine is lower then this value, you can o\
nly select up to the maximum spin speed.
C Water and power consumption may vary subject to the changes in water pressure, water hardness and temperature, ambient temperature, type and amount of laundry, selection of auxiliary functions and spin speed, and changes in electr\
ic voltage.
C You can see the washing time of the...

24EN
Auxiliary function selection
Use the following auxiliary functions according to your daily needs. Select the desired auxiliary functions before starting the programme. Furthermore, you may also select or cancel auxiliary functions that are suitable to the running programme without pressing the Start / Pause button when the machine is operating. For this, the machine must be in a step before the auxiliary function you are going to select or cancel.
If the auxiliary function cannot be selected or...

25EN
Delayed Start (In some models only)
With the Delayed Start function the startup of the programme may be delayed up to 3, 6 or 9 hours.
C Do not use liquid detergents when you set Delayed Start! There is the risk of staining of the clothes.
Open the loading door, place the laundry and put detergent, etc. Select the washing programme, temperature, spin speed and, if required, the auxiliary functions. Set the desired time by pressing the Delayed Start button. When the button is pressed once, 3 hours...

26EN
for 3 seconds.
C In addition to the method above, to deactivate the Child Lock, switch the Programme Selection knob to On / Off position when no programme is running, and select another programme. 
C When the power is restored after a power failure or after your machine is unplugged and plugged in again, the Child Lock will not be deactivated when the machine resumes operating.
Progress of programme
Progress of a running programme can be followed from the Programme Follow-up indicator. At the...

27EN
programme will start depending on the step the previous programme was canceled in. For example, it may take in additional water or continue to wash with the water inside.
C Depending on the step where the programme was canceled in, you may have to put detergent and softener again for the programme you have selected anew.  

28EN
6 Maintenance and cleaning
Service life of the product extends and frequently faced problems decrease if cleaned at regular intervals.
Cleaning the detergent drawer
Clean the detergent drawer at regular intervals (every 4-5 washing cycles) as shown below in order to prevent accumulation of powder detergent in time.
1. Press the dotted point on the siphon in the softener compartment and pull towards you until the compartment is removed from the machine.
C If more than normal amount of water and...

29EN
cleaned as they do get dirty.
1. Close the taps.
2. Remove the nuts of the water intake hoses to access the filters on the water intake valves. Clean them with an appropriate brush. If the filters are too dirty, take them out by means of pliers and clean them.
3. Take out the filters on the flat ends of the water intake hoses together with the gaskets and clean thoroughly under running water.
4. Replace the gaskets and filters carefully in their places and tighten the hose nuts by hand.
Draining...

30EN
a. Pull the emergency draining hose out from its seat
b. Place a large container at the end of the hose. Drain the water into the container by pulling out the plug at the end of the hose. When the container is full, block the inlet of the hose by replacing the plug. After the container is emptied, repeat the above procedure to drain the water in the machine completely.
c. When draining of water is finished, close the end by the plug again and fix the hose in its place.
d. Turn the pump filter to...