Bose 3 2 1 Gsx Owners Guide

27
SETUP
ItalianoSvenska
Deutsch Nederlands
English Français
Español
2. Insert the antenna plug into the AM antenna 
connector. 3.
Press firmly to attach the antenna loop to the 
provided stand.
Small tabs on the antenna ring fit into notches on 
the stand.
4. Place the antenna in an upright position and at 
lease 20 inches (50 centimeters) from both the 
media center and the Acoustimass
® module.
5. Continue with   on the next page.
8
 

28
SETUP
Italiano
Svenska Deutsch
Nederlands English
Français Español
1. Notice the large plug at one end of the 
Acoustimass module power cable.
8
Connecting 
the module to 
a power outlet
What you need to use:
Acoustimass® module power cable
Acoustimass module
 

29
SETUP
ItalianoSvenska
Deutsch Nederlands
English Français
Español
2. Insert this plug into the power connector that is 
marked   on the Acoustimass
® module.
Note:  On some systems, the Acoustimass 
module includes one of two controls.
On 220-240V models only , turn the 
POWER switch to on (  l ).
On dual-voltage systems only , set
the voltage switch for the power
that is appropriate to the region 
where you use the system.
3. Plug the other cable end into the AC (mains) power.
CAUTION:  Bose...

30
SETUP
Italiano
Svenska Deutsch
Nederlands English
Français Español

® 
remote to control your TV and other components 
connected to the media center.
Inserting the remote batteries
The two supplied AA batteries go into the compartment 
on the back of the remote control.
1. Slide the battery compartment cover off.
Symbols inside the compartment show how to 
match the – and + symbols on the batteries. 
2. Insert the two batteries, making sure to match the 
markings.
3. Slide the cover back until it...

31
SETUP
ItalianoSvenska
Deutsch Nederlands
English Français
Español
Setting the remote for your TV 
® remote with your TV, you must set 
the remote for the proper TV device code. 
1. Refer to the list of “Device codes” on page A-1. 
2. In the list for TVs, find the brand of your TV.
3. Write down several codes for your brand so you 
can try more than one, if needed. 
Note:  If one code works to turn your TV on and off but 
does not change channels, you can try other codes to 
find one that provides more...

32
SETUP
Italiano
Svenska Deutsch
Nederlands English
Français Español
Controlling another component

on, follow these steps.
1. In the Device Codes list, find the codes for the type 
and brand of your component.
2. 
® remote, press and hold the 
button for this component for several 
seconds.
Wait until the red light at the top of the 
remote turns on.
3. Enter the device code for your component. 
The light turns off briefly as you press each key.
4. Make sure the light turns  off completely after all...

ItalianoSvenska
Deutsch Nederlands
English Français
Español
33
FIRST-TIME USE
Trying out the DVD
When you first turn on the system, you can play the 
provided DVD to get a step-by-step review of your 
setup.
1. Before you continue, make sure that:
 All of the cables needed for your setup are  connected.
 
® system 
remote control.
 The system power cord is plugged in at both  ends.
2. Turn on your TV. 
 Use the TV On/Off button on the  
to control your TV.
 Or use the remote control that  came with the...

Italiano
Svenska Deutsch
Nederlands English
Français Español
34
CONTROLS AND INDICATORS
The remote control
Aim the 1® remote control at the media center or at 
the component you are cont rolling with the remote. 
1. Press the white On/Off button near the top of the 
remote control.
The system turns on to the last used source*, which 
may be:
 Stored music
 DVD
 AM

 SAT
 If your media center does not respond to the 
remote:
 Make sure there is nothing blocking the front dis- play where signals are...

35
CONTROLS AND INDICATORS
ItalianoSvenska
Deutsch Nederlands
English Français
Español
Power and source buttons  
® system on and off.
Play begins with the source last used. 
Silences or restores the sound.
Selects stored CDs as the music source and 
turns on the system.
Play begins in the play mode last used.
Selects the built-in CD/DVD player as source 
and turns on the system.
Selects the built-in FM/AM radio as source 
and turns on the system  to the station last 
used. 
Switches between FM and AM...

36
CONTROLS AND INDICATORS
Italiano
Svenska Deutsch
Nederlands English
Français Español
Menu and movement buttons
 Enters the library of stored CD tracks.
Enters the Settings menu for the source that is 
playing.
Enters the System main menu.
Displays the DVD menu for  the current disc on 
your TV screen.
Displays an on-screen program guide for any 
connected video devices that provide a guide.

® Settings or System menu. 
Exits the on-screen menus or information 
screens of other conn ected video...