Bose 321 GS Series II DVD home entertainment system Sold from July 2004 to present User Manual

SYSTEM
 SETUP
21
SYSTEM SETUP
Dansk Italiano SvenskaDeutsch Nederlands English FrançaisEspañol
Figure 17
Advanced setup: TV, VCR 
and cablesatellite box
Cable/satelliteCBLSAT
S-video 
output Cable/satellite
(CBL
SAT)
service
Media center’s 
S-video output 
to TVCBL
SAT
signal to 
VCR
VCR analog audio
VCR
TV Media center
CBLSAT
signal to 
TV
CBLSAT analog 
audioCBLSAT
digital audio
Note:For more information on advanced connections, refer to the DVD setup disc that came 
with your 3•2•1 Series II...

22
SYSTEM
 SETUP
SYSTEM SETUP
Dansk Italiano Svenska DeutschNederlands EnglishFrançais Español
Connecting a game console
Connect the audio output of a game console to the AUX Left and Right input jacks. Con-
nect the video output of the game console to the C (composite) Video IN jack.
Figure 18
Game console connections
Game console 
connection panel
TV connection panelMedia center
IMPORTANT
If you connected your game console this way, you will 
need to select the AUX source on the 3•2•1 remote in 
order...

SYSTEM
 SETUP
23
SYSTEM SETUP
Dansk Italiano SvenskaDeutsch Nederlands English FrançaisEspañol
Installing the remote control batteries
1.On the back of the remote, slide open the battery compartment (Figure 19).
2.Insert the two supplied AA (IEC-R6) 1.5V batteries, or their equivalent, as shown. Match 
the plus (+) and minus (–) marked on the batteries with the plus (+) and minus (–) inside 
the battery compartment.
3.Slide the battery compartment cover back into place.
Note:
Replace the batteries when...

24
SYSTEM
 SETUP
SYSTEM SETUP
Dansk Italiano Svenska DeutschNederlands EnglishFrançais Español
Connecting the power cord
CAUTION: For dual voltage models only, be sure to set the dual voltage switch on the back of 
the Acoustimass® module to the appropriate voltage for your area (115V or 230V) before con-
necting to power. If you are not sure about the proper voltage for your area, consult your local 
electrical authorities.
1.Insert the small connector end of the power cord into the AC INPUT connector...

SYSTEM
 SETUP
25
SYSTEM SETUP
Dansk Italiano SvenskaDeutsch Nederlands English FrançaisEspañol
Checking your system setup
Follow these steps when turning on your system for the first time. Be sure to perform step 4 
and play the setup DVD. The setup DVD can help you verify that you set up your system cor-
rectly for proper sound performance.
1. Check the following before you continue:
• All cables are connected for the setup you chose.
• The batteries were installed in the remote control.
• The power...

26
SYSTEM
 C
ONTROLS AND
 INDICATORS
Dansk Italiano Svenska DeutschNederlands EnglishFrançais Español
SYSTEM CONTROLS AND INDICATORS
Remote control
Remote 
status
LED• Turns the system on or off.
Status LED:
• Remains off (unlit) during normal operation.
• Remains on during setup mode. Turns off briefly with each key press.
• Blinks rapidly eight times if the wrong key is pressed during setup or if an 
unavailable device code is entered.
• After ten seconds of no key presses, blinks rapidly eight times...

SYSTEM
 C
ONTROLS AND
 INDICATORS
27
SYSTEM CONTROLS AND INDICATORS
Dansk Italiano SvenskaDeutsch Nederlands English FrançaisEspañol
Remote control – cont.
• Puts the Settings menu for the current source on your TV screen or media 
center display.
• Puts the System menu on your TV screen.
• Puts the DVD menu of the currently loaded DVD disc on your TV screen.
• Puts the main menu of a cable/satellite box, VCR, or DVR on your TV 
screen (if supported).*
• Puts the TV, cable, satellite, or DVR program...

28
SYSTEM
 C
ONTROLS AND
 INDICATORS
SYSTEM CONTROLS AND INDICATORS
Dansk Italiano Svenska DeutschNederlands EnglishFrançais Español
Remote control – cont.

• Raises or lowers the volume of the current source. 
• Pressing + restores muted sound from the current source.
• Pressing – lowers the volume of the current source, but does not restore 
muted sound.
• Skips to the next or previous TV channel,* CD track, or DVD chapter.
• Stops the disc player.
•For DVDs only, the disc stops and the system saves...

SYSTEM
 C
ONTROLS AND
 INDICATORS
29
SYSTEM CONTROLS AND INDICATORS
Dansk Italiano SvenskaDeutsch Nederlands English FrançaisEspañol
Remote control – cont.
Aspect ratio or Teletext On/Off control
You will see one of two symbols below this button on your remote control. The symbol 
defines the function.
Recording/Cable or Teletext controls
These four buttons will be marked in one of two ways on your remote.The markings 
define how the buttons are used.
* Requires special remote settings. See “Setting up...

30
SYSTEM
 C
ONTROLS AND
 INDICATORS
SYSTEM CONTROLS AND INDICATORS
Dansk Italiano Svenska DeutschNederlands EnglishFrançais Español
Setting up your remote to control other audio/video devices
Your remote can be set up to control other audio devices such as a TV, VCR, DVR or 
cable/satellite box by entering a device code while in the setup mode.
•If you know the device code, follow the instructions under the heading, “Direct 
entry of a device code”below. Device codes are listed in the back section of...