Boxlight Xd-15c Users Guide

Introduction
7 BOXLIGHT XD-15c User’s Guide
Adjuster
The projector is equipped with a quick-release adjuster foot and button for adjusting 
its tilt angle.
1. Lift the projector up and press the adjuster button to release the adjuster.  
2. The adjuster will drop into position and be locked.    
Projector Features
The projector integrates high performance optical engine projection and user-friendly 
design to deliver high reliability and ease of use.
The Projector offers the following features:
 Compact...

Introduction
8 BOXLIGHT XD-15c User’s Guide
Remote Control Description     
Remote Control Features
The remote control sensors are located in the front/ back of the projector. The 
distance between the sensor and the remote control should not exceed 6 meters (20 
feet).
( 

Introduction
9 BOXLIGHT XD-15c User’s Guide
FREEZE
The image can be frozen when FREEZE is pressed. A “Pause” icon will appear in the 
lower right corner of the screen for three seconds.  To release the freeze function, 
press the FREEZE button, RETURN button or SOURCE button (when the input 
source is switched over during display) again. A “Play” icon will appear in the lower 
right corner of the screen for three seconds when the freeze function is released.     
ZOOM IN/OUT
By pressing ZOOM IN +, the...

Introduction
10 BOXLIGHT XD-15c User’s Guide
Installing or Replacing Batteries
 Push and slide the battery compartment lid in the direction shown.
 Install batteries as indicated by the diagram inside the compartment.
 Position the lid over the compartment and snap it back into place.
  
Caution
Avoid excessive heat and humidity. There may be danger of an explosion if 
batteries are incorrectly replaced. Replace only with the same or equivalent 
type recommended by the manufacturer.  Dispose of used...

Installation
11 BOXLIGHT XD-15c User’s Guide
INSTALLATION
Screen Size
Place the projector at the required distance from the screen according to the desired 
picture size (see the table below). 
Connecting to Various Equipment 
It only takes a few seconds to connect your projector to your computer/notebook, 
VCR or other systems. However, a Mac adapter (an optional accessory) is needed for 
connection for Macintosh users. 
   
Screen Size (Max.)
L. Projection 
distance (cm/in)Screen Size (Min.)
Diagonal...

Operation
12 BOXLIGHT XD-15c User’s Guide
OPERATION
Start Up
1. Plug the power cord into a wall socket.
2. Press POWER for 1 second.
 The back-lit POWER key blinks green and stays green when the power is turned 
on.
(When the power is turned off, there is a 60-second cooling period before the 
projector can be re-started.)
3. Switch on all connected equipment.
Power
Power
Projector        Remote Control 

Operation
13 BOXLIGHT XD-15c User’s Guide
Digital Keystone Correction
Keystoning refers to the situation where the projected image is noticeably wider at 
either the top or bottom. To correct this, press KEYSTONE +/- (hot key) on the 
control panel of the projector or on the remote control, then adjust the sliding bar 
labeled Keystone, as needed. Press + to correct keystoning at the top of the image. 
Press - to correct keystoning at the bottom of the image.
Auto Adjustment
In some cases, you may have...

Operation
14 BOXLIGHT XD-15c User’s Guide
Source Selection
When several input sources are available, press the SOURCE key to make a selection 
from the control panel of the projector or the remote control.  
Menu System
Press Menu for the main menu and press 3or 
4 to select a sub-menu. Press Menu 
again to select items in the sub-menu.  
ProjectorRemote control
Auto SourceSourcePowerPower
Menu Bar
Sub-menu Display Image Source Control PIP
PCKeys t o n e
Brightness
Contrast
Phase
H.SizeAuto resize...

Operation
15 BOXLIGHT XD-15c User’s Guide
1. Display Menu    
KeystoneCorrects any keystoning of the image. 
BrightnessAdjusts the brightness of the image.  
ContrastAdjusts the degree of difference between darkness and lightness of 
the image.   
PhaseAdjusts to avoid the occurrence of f licker. 
*This function is not available when the input modes are Video, S-
Video.
H.SizeAdjusts to f it in the desired image size.*This function is not available when the input modes are Video, S-
Video.
Color...

Operation
16 BOXLIGHT XD-15c User’s Guide
2. Image Menu   
   Auto resizeMakes the best f it of the image to the screen,
 
H-positionAdjusts the horizontal position of the projected image.  
V-positionAdjusts the vertical positon of the projected image. 
Color Temp.Adjusts the color temperature to f it your preference.
InformationShows the current resolution.
RatioUsers have 2 options for the image ratio.
1. 4:3 (Normal)  2. 16:9 (Wide)
*This function is not available when the input modes are PC, YPbPr....