Candy Cdcf 6s Instruction Manual

9WARNING! 
 

10About Electricity Connecting
.
Insure proper ground 
exists before use
CAUTION , for personal safety:
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIANCE.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE THIRD GROUNDING PRONG FROM THE POWER CORD.
Electrical Requirements  
This dishwasher is designed for operation on an adequately wired individual 220~240VAC,50~60HZ. Use required fuse 10 amp. 
Fused electrical supply is required-copper wire only. Time delay fuse or circuit breaker...

11How to Drain Excess Water 
From Unicouple Hoses
If the sink is 34 or higher from the floor, the excesswater in Unicouple\
 hoses
cannot be drained directly into the sink. It will be necessary to drain \
excess
water from hoses into a bowl or suitable container that is heldoutside a\
nd lower
 than the sink.
Positioning the Appliance Position the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent 
cabinets or wall. The dishwasher is...

12Problem
Possible Causes What To Do
Fuse blown, or the
circuit breaker acted Replace fuse or reset circuit breaker. Remove any other 
appliances sharing the same circuit with the dishwasher
NoiseSound from soft food shredding action and detergent cup
opening.
Utensils are not secure
in the baskets or something
small has dropped into
the basket To ensure everything is secured in the dishwasher.
Motor hums Dishwasher has not been used regularly. If you do not use it 
often, remember to set it to fill and...

13Before  calling  for  service . . .
Problem
Possible Causes What To Do
Cloudiness on
 glasswareCombination of soft
water and too much
detergent Use less detergent if you have soft water and select a 
shortest cycle to wash the glassware and to get them clean. 
Yellow o r b rown f ilm
on inside surfacesTea or coffee stains using a solution of 1/2 cup of bleach and 3 cups warm water
to remove the stains by hand. 
WARNING
You have to wait for 20 minutes after a cycle to let the heating
elements cool down...