Candy Cdi 2012e10 S User Instructions

User instructions
EN
CDI 2012DISHWASHER
 

3
CONTENTSSafety advice
Setting up, installation
Water softener unit
Adjusting the upper basket
Loading the dishes
Information for test laboratories
Half load washing
Loading the detergent and rinse aid
Cleaning the filters
Some practical hints
Routine cleaning and maintenance
Description of the controls
Technical data
Operating the programmes and special functions
Programme selection 
Identifying minor faultspag.    4  
pag.    5
pag.    8
pag. 10
pag. 11
pag. 13
pag. 14
pag. 15
pag. 17
pag. 18
pag. 19...

Fuses and plugs
This appliance should be used only on a
socket with a minimum rating of 13 Amp.
Our ready-fitted plug is already equipped
with a 13 amp fuse which is BS 1362 ASTA
approved.
Any replacement should be exactly the
same.
If the fuse cover is lost, do not use the plug
until it is replaced. 
Acorrect replacement fuse cover (obtainable
from your dealer or Electricity board) must be
the same colour as shown or named on the
insert on the base of the plug.
Manufacturer declines all responsibility...

7
Connecting the outlet hose■The outlet hose should disharge into a
standpipe, making sure that there are no
kinks (fig. 4).
■The standpipe must be at least 40 cm
above floor level and it must have an
internal diameter of at least 4 cm.
■It is advisable to fit an anti-odour air trap
(fig. 4X).
■If necessary the outlet hose can be
extended up to 2,5 m, provided that it is
kept at a maximum height of 85 cm
above floor level. The extension pipe is
available from the After Sales Service
Centre.■The hose can...

Loading the salt■On the bottom of the machine there is a
container for the salt for regenerating
the softener.
■It is important to use only a salt that is
specifically designed for dishwasher.
Other types of salt contain small quantities
of insoluble particles which over a long
period of time may affect and deteriorate
the softener performance. 
■To add salt, unscrew the cap of the con-
tainer on the bottom and then refill the
container. 
■During this operation a little water will
overflow; but keep...

11
LOADING DISHESUsing the upper basket■The upper basket is provided with mobi-
le racks hooked to the sides of the
basket which can be regulated in two
positions: upright and lowered. In the
lowered position the racks may be used
for tea and coffee cups, kitchen knives
and ladles. Glasses with stems may be
safely hung on the ends of the racks.
Glasses, cups, saucers and dessert
plates may be loaded under the racks.
■Soup plates and ordinary plates may be
loaded with the rack in the upright
position....

Lower basket (fig. 6)
M= 8 + 4 soup plates
N= 11 + 1 dinner plates
O= 12 dessert plates
P=serving dish
Q=cutlery
13
Upper basket (fig. 5) 
A= 5 + 5 + 2 glasses
B= 12 saucers
C= 4 + 4 + 4 cups
D= small bowl
E= medium bowl
F= large bowl
G= 1 + 1 forks
H= 1 + 1 serving spoonsI= 3 + 3 + 3 + 3 dessert spoonsL= 3 + 3 + 3 + 3 teaspoons
INFORMATION FOR THE TEST LABORATORIESGeneral programme comparison  (Ref. EN 50242 Standards) (see programmes selection)
1.Upper basket position: low
2.Normal load
3.Shine...

LOADING THE DETERGENT
AND THE RINSE AIDFilling the detergent containerIMPORTANT
It is essential to use a detergent
that is specifically designed for
dishwashers either in powder, liquid
or tablet form.
“FINISH” gives very good results and can
be easily obtained.
Unsuitable detergents (like those for
washing up by hand) do not contain the
proper ingredients for use in a dishwasher,
and stop the dishwasher from working
correctly.Normal washThe detergent container is inside the door
(fig. A “2”). If the lid...

17
123
CLEANING THE FILTERSThe filter system(fig.A “4”) consists of: 
a central containerthat traps the larger
particles;
a flat gauzethat continuously filters the
wash water;
a micro filter, located beneath the gauze,
that traps the tiniest particles ensuring a
perfect rinse.
■To achieve excellent results every time,
the filters should be checked and
cleaned after each wash. 
■To remove the filter unit, simply turn the
handle anticlockwise (fig. 1).
■For ease of cleaning, the central container
is...

19
WHEN CYCLE IS FINISHEDAfter every wash it is essential to turn off
water supply and to switch off the machine
by pressing the On/Off button to the off
position. 
If the machine is not going to be used for
some time, it is advisable to follow these
rules:
1.doan empty wash with detergent in order
to clean the machine of any deposits;
2.pull out the electric plug;
3.turn off the water tap;
4.fill the rinse aid container; 
5.Ieave the door ajar;
6.keep the inside of the machine clean;
7.If the machine is...