„Intelligent Function Settings
When you click [Add] in the [Detection Setting List],
the [New Detection Settings] dialog box is displayed.
Set the [Detection Setting Number] and [Detection
Type] of the detection setting you want to add, and
then click [OK].
Up to 15 different detection settings can be
(1) [Detection Setting Number]
Specify a detection setting number from 1 to 15 for the
detection area you want to set.
(2) [Detection Type]
Select detection types that suit your purpose from
[Moving Object Detection], [Abandoned Object
Detection], [Removed Object Detection], [Camera
Tampering Detection], or [Passing Detection]. For
details on detection types, see p. 97.
To enable detection settings, select [Enable these
Clear this checkbox to disable a setting.
Set detection criteria while operating the camera and
checking the video in the video display area.
Click [Save settings] to save the settings in the
You can check the detection status of the specified
detection settings in the event display panel (p. 139).
1Add detection settings.
2Enable Detection Settings.
3Set detection criteria ([Detection Criteria] tab p. 103).
4Set operations to be performed when a change in a
subject is detected ([Event] tab p. 104).
5Save the detection settings in the camera.
6Check the detection result.
Notes on intelligent function settings and operation
When setting intelligent function, do an actual detection test
to confirm that detection will be performed correctly.
When the entire screen is exposed to sudden changes in
brightness, detection may not be performed as intended for
up to 5 minutes.
If [Auto] is used in [Day/Night] settings or automatic
switching between [Day Mode] and [Night Mode] is
performed when a timer is used, [Restarting intelligent
function. Please wait.] is shown and intelligent function will
restart. Detection will not be performed while intelligent
function is restarting.
If the camera is operated during intelligent function setting or
operation, [Restarting intelligent function. Please wait.] is
shown and intelligent function will restart. Detection will not
be performed while intelligent function is restarting.
If [Video] > [Video Size Set] on the Setting page is changed,
be sure to change the preset position setting (VB-S30D/VB-
S31D only) and intelligent function settings, and check the
operation. The intelligent function may not operate,
depending on the settings.
Set intelligent function again if the angle of view is changed
through camera operation, or the camera position of a preset
or home position is changed using Preset Setting Tool.
If an [Enable] detection setting exists under [Status] in the
[Detection Setting List] while the camera position is locked,
control privileges cannot be obtained by VB Viewer or RM.
Also, the custom settings automatic control will no longer run.
Objects or portions where there is little contrast in color or
brightness with the background may not be detected.
Small objects and changes on the screen may not be
Partial or entire changes in light on the screen may trigger
If multiple objects overlap, the detection status may change.
In particular, passing may not be detected or may be
detected at the wrong timing.